Tweaks for EMM CDSA SE ... ?

Alot of interesting works been done by you guys. My CDSA has been fairly stock standard on a slung isolation stand for a good while. I've recently tried some Teo Liquid cables that have added a good step in the right direction but more in line with thread the other tweaks I've been trying are Acoustic Revive's RCG-24 Ground Conditioner and their RR-77 Pulse Wave thing. Not sure on the RR-77 but the RGC-24 makes a difference. In my system take it out and you lose some of the music, decay isn't as natural, vocals lose some of their character and instruments don't carry quite the same weight. I'll be keeping the RCG-24 and might revisit the 77 when I've gotten more used to the system as it is now

Anyone who would like information about the amazing results obtained by putting 2 XLR ICs in series from my EMM to my integrated amp can PM me.

I have done more tweaking of my EMM that greatly enhances the improved 3D effect of putting ICs in series. Those who would like the details can PM me.

Hello everyone.

I just came across this thread.

I was originally going to sell the SE and move to the XDS1. I think I am glad I waited.

The Furutech fuse is a no brainer.

I have PM'd Sabai about the ICs.

A few questions;

Unless I am mistaken, Furutech makes an IEC connector that is installed into the unit. The inside end is an EMI/RFI filter. Is there enough room for this modification?.

I have the NANO, and am wondering if there are any places inside the unit I can use it?. I am hopeing to only open the unit once.

Cousinbillyl,

There is enough room inside to replace with the Furutech IEC since Emm also use a filter but you might have to modify the IEC to fit.

You can unplug all connections that can be unplug and nano them. I've done all the connections by the IEC and joining wires and all those white computer looking connector pins. Just carfully pull them out and nano them. Don't over apply the nano as it will sound dull. You will be shocked with the result.

Hope this helps