Upgrade Interconnects/Cables or…?


At 71 years of age, I have two possible upgrades I’d like to perform. After that I’m done, except for the usual tweaks (i.e., tubes, isolation, etc.). I’m very happy with the system I’ve built over the years, and it fits my room (medium), and the sound I’ve been after has been realized. I am guilty of concentrating on the main components of my system, and not paying much attention to what connects them. And, I’m in the hunt to upgrade my line stage…Maybe? So, what to do first, and perhaps I can hold off on the second option entirely? My budget is under $6,000 for either one.

I’m still an analog guy, even though I do have a DAC, Streamer, and NAS. My concentration here is for my phono playback. My interconnects and cables are old, but even so, each time I’ve upgraded a main component I have heard definite and sometimes significant improvement. Whenever I purchased interconnects/cables in the past, they were always decent ones at the time.

Option 1 - I’m looking at replacing the following interconnects/cables for my phono playback…

Turntable, Arm, Cartridge: Upgraded TW Acustic Raven, Ortofon RS 309D, Ortofon Verismo

               Current Phono Cable: Cardas Cross

Phono Stage: Tron Seven with the Reference caps

               Current Interconnect to Line Stage: Cardas Cross Reference

Line Stage: Boulder L3AE and recently upgraded the caps by Boulder

               Current Interconnect to Amps: Crystal Piccolo

Amps: TW Acustic 300B Monoblocks

               Current Speaker Cable: WireWorld Silver (original)

Option 2 - My system is fully unbalanced, so when considering a line stage, I don’t want to pay extra for designs that benefit from using the balanced side when I won’t be using that. One consideration for replacing my Boulder, is the Audible Illusions L3B.

So, which option might you choose if you could only choose one? And, what might you go with?

Thanks,

Kenny

kennythekey

Kenny…the fact that you don’t have sidewalls and corners is not entirely a downside. You can try treating the front wall but I’m not sure it will accomplish what you’re looking for. You need a more transparent and open sounding amplifier and speakers combination. Your cardas cables aren’t helping but I don’t believe they’re the single culprit. 

soix - The reason for the speakers wanting corners is for bass. There are 2 bass drivers in the rear of each speaker that are ported out the back. By themselves in this setup, the speakers can normally go down to 30hz. With the addition of the custom subs everything improved including the extra detail. So, my system sounds better than it did with corners. With both my old setup and this one, I still wished for more air around me. You may be right, but the common denominator in both cases are the same cables and the Boulder line stage being in both locations. However, the amp I was using in my old setup was a CJ Premier 11a. I will definitely try moving my speakers out into the room.

ghdprentice - Thanks for the kind words. And, switching the conversation to the line stage. I’m also wondering if losing the painting on my front wall and adding some treatment for dispersion would help open it up in my direction?

tablejocky - Okay, that’s what I started to think about regarding treatments. Regarding the MR71, I can’t come up with the company anymore. However, Audio Classics (audioclassics.com) sells original cabinets.

Kenny

Hey Kenny I have to say your system looks fantastic to me and the way you describe the sound is what most of us are going for. I think your cables are just fine and your phono stage too if it were me I'd add a tubed linestage to the mix in place of the Boulder. Tron makes good ones and there are so many other choices out there, you are working with a great dealer sounds like I'm sure they may have some suggestions.

I’d still try pulling the speakers a few feet into the room and see if it yields any improvement in the areas you’re interested in.  You didn’t say if you’ve tried that. 

@kennythekey  I agree with previous comments about moving the speakers out into the room. It should improve the depth of the sound. Have you tried using the “Rule of Thirds”. That was the secret for me locking the speakers into the room.  Good luck!