Very short speaker cable length recommended?

I would say it depends on your amp. High feedback amps work better with short speaker cable runs. At least mine does. I went through a selection process using long and short cable runs - both cheapo 12 ga twisted strand copper and high quality cables. Ended up with 6 foot high quality cables sounding best. At least to my ears.

No doubt, Timru.

I've witnessed major debates in car forums regarding oil change intervals. You have recommendations from both oil and car manufacturers, and then you have the entire dino versus synthetic argument influencing change intervals. Then do you change both the filter AND the oil?

It sounds so much like analog versus digital, copper/silver, tubes, solid state, etc... It's all so confusing, but ultimately hopefully leaves us more informed to make our own deicisions.

I'll be watching this thread.

It is counter-intutive but I have two thoughts:

(1) It is possible that very short cables restrict speaker placement and thus affect sound indirectly, where as longer ones let you find optimal placement.

(2) Is it conceivable that some speakers were designed with either long or short cable and would sound better accordignly? Not sure it makes sense but just a thought.

Mapleshade actually claims that 8 ft is the optimal length not the minimum. They prefer not to sell 10 or 12 ft runs. They also don't prefer double runs for bi-wiring, instead selling an inexpensive 2 or 3 inch jumper. Hardly a philosophy designed to sell more wire.

JI35 reminded me of when I first contemplated changing from biwired Kimber 8TC to Mapleshade Double Helix. Frankly, I assumed I'd biwire with the new stuff. Pierre wouldn't sell it to me, said to try it single-wired (with his ribbon jumpers) and see if I didn't like it better than the Kimber. It sounded so MUCH better than the Kimber that I didn't even consider going biwire. And I sold the used 8TC for about twice what the new Mapleshade cost.