VPI Headshell weight question

That makes sense. I've never setup a turntable myself, although I just bought a digital scale, I have Michael Fremer's DVD, and need to learn sooner or later.

I was hoping that this might be a good time to start if I only had to make 1 or 2 adjustments.

Thanks.

"I was hoping that this might be a good time to start if I only had to make 1 or 2 adjustments."

If you've removed the cartridge and you're adding weight, you'll have to revisit ALL the adjustments. To get it correct, the VPI table and arm take a lot of time and care.

Mike

So I got brave enough to install the headshell weight. Even though it was my first time doing any adjustments, I took my time, watched Fremer's DVD and thought I did a good job.

I have VTF at the high end of the cartridge recommendation. I adjusted Azimuth and even lowered the arm height (looked like it was a tad higher at the pivot).

I used the VPI jig (don't have a mint tractor yet).

However, the sound is rather harsh. Highs are thin, metallic sounding and (I think) distorting.

Can someone suggest what aspect of the setup might be off?

Thanks!

I'm also in the process of adding a 3 gram headshell weight to a JMW 9 arm.

I found that by placing the weight between the cartridge and the headshell had caused the rear of the arm to be far too high (after VTF adjustments) to the point where the stylus lift bar, adjusted to its highest setting, will not even be high enough to lift the arm off the record.

I'll have to go back and place the weight back onto the headshell.

That's strange. The weight is very thin - While I had to adjust VTF & VTA, it didn't make that type of difference.