2. analog
  3. 1227196554

VPI HW-19 Original Motor Turnoff Pop

Anyone had any success in eliminating the pop that occurs when turning off the motor and the preamp is not muted?

I sometimes forget to mute my preamp before switching the motor off. I understand there is a cap inside the motor that is designed to control this but, in my case, it is ineffective.

Any advice is much appreciated.
narrod
narrod OP
1,064 posts
 
The toggle switch cured the turnoff transient? That's all you did? Sounds like an easy fix.
yogiboy's avatar
yogiboy
5,638 posts
 
HI,
I FOUND THAT THE STOCK PUSHBUTTON WAS VERY NOISY.WHEN I REPLACED WITH A NICE TOGGLE IT MADE A BIG CHANGE.IT EVEN LOOKS NICE IN CHROME.REMEMBER TO GET ONE WITH A LONG STEM SO IT FITS THROUGH THE BASE.
GOOD LUCK
YOGIBOY
yogiboy's avatar
yogiboy
5,638 posts
 
HI,
BEFORE YOU CHANGE SWITCH PLUG VPI INTO A POWER STRIP WITH AN ON OFF SWITCH AND TURN ON TABLE WITH THAT THEN YOU WILL KNOW FOR SURE THAT IS THE PROBLEM.
narrod OP
1,064 posts
 
Good advice. I'll try that first.
More to discover