2. analog
  3. 1355598927

VPI owners.......

If you have the platter that has the three leveling set screws, ( mine is the HW-19 ) here's a free and accurate way to level/true the platter. Cut a business card on a gradual slope. As you slowly glide it under the platter while spinning, you'll hear/feel the contact. It's good to mark the point at which you're adjusting with a tape dot so you'll be adjusting from the same point each time. Sit back and enjoy.
128x128slaw
frogman
7,452 posts
 
****@Slaw If you bought a used VPI and the previous owner screwed with the platter screws you are SOL! Better to buy new.****

VPI reset and balanced the set screws in my MK5 platter free of charge; didn't even charge me return shipping. Great customer service.
bpoletti
1,553 posts
 
@Frogman Did you need to send the table back or just the platter and bearing? (Just curious)
frogman
7,452 posts
 
Just the platter and bearing.
redglobe
223 posts
 
Hi Slaw, Thank you for providing this simple and inexpensive method to leveling the platter.
brf
1,715 posts
 
Using a business card as a gauge gets you close and is inexpensive, but China made run out gauge can be had for $35 and make the whole process simple and very accurate. Markd51 method is a proven winner.
More to discover