Want to make sure I have the correct settings for my phono pre-amp


So I have a Jolida JD9 II phono pre-amp.

I have a Hana SL MC Cart. This Cartridge calls out for >400ohms for the impedance.

I have the following settings set on the Jolida:

- 1000ohm for the impedance

- Using the High Output for the interconnect (since the Cart is low output and according to the instructions). The manual states to use these outputs for Integrateds and line stage pre-amps

- For the Voltage Gain dip switches: set to MC Low

The Impedance setting of 1000ohms, I know I can try different settings but for the other settings, I believe that is what I am supposed to use according to the instructions but wanted to see if anyone else has used this phono pre-amp or have any opinions.

Using the high outputs definitely sets the gain really high as on my Integrated, I turn up the volume just a couple of notches and the music is already pretty loud.





I’d also try the 300ohm impedance setting on the pre. I have a Hana SL and it seems to like something very close to 400ohms in my systems. 1K may sound a tad too zippy depending on the the rest of your gear. Easy to try and let your ears be the guide.

Try the Low outputs for the interconnects.  I think you'll find you have less distortion and better control over the volume.  I'd give the 300 ohm setting a try and see if you like that better.  Leave the dip switch on MC Low as you have it.  I've never tried the Hana SL with my Jolida, but the recommended 400 ohm works well with my other phono stages.

According to specs:

Phono Stage:

            MM:                            60 dB, 5 mV 

            MC High:                    75 dB, 0.5 mV – 1.5 mV

            MC Low:                    85 dB, 0.25 mV – 0.5 mV

If 60,75 and 85 dB are gain value, set it to MC High 75 dB gain will give you better control of volume level.