What do you see as the downside of tubes?


I have decided on getting a tube amp and it will be the integrated Mastersound 300B driving a pair of Living Voice Avatars, so at least that decision has been taken.

My main question is what you see as downsides of having a tube amp. As I've decided on getting an integrated tube it's really about what the downsides are I might want to know about beforehand.

The ones I'm aware are the following.

-The tubes need to be replaced and in the case of a 300B this will be somewhat costly.

-Bias is another issue but I'm not sure how big an issue. Do you plug in your meter every so often or just when you roll tubes or replace a dead one? The meter as such isn't gonna be a big issue as I don't think it's that expensive.

-Heat won't be a big issue as we have no kids nor a nosy dog that could get burned. Hope my electricity bill isn't gonna go through the roof, but then again, I can't quite imagine that.

I'd appreciate if you could add whatever your experiences are regarding this question are as I'd like to know more before I buy it.

Thanks
krauti
About tube-rolling, I was always a fan of NOS tubes and am now having second thoughts. I was using xf1 Mullard EL34s as driver tubes in my SET monoblocks and tried some of the reissue Genalex/Gold Lion KT77s instead and was floored at the improvement. Since the KT77s, while not exactly cheap, are MUCH less costly than the Mullards, it was definitely a win-win. Dave
Krauti:

You cannot run a tube amp 24/7 because the output tubes pass a lot of current and will wear out too quickly. This is generally not the case with gear like tube preamps or tubed DAC's that use small-signal tubes (little tubes) - 24/7 operation with small-signal tubes usually extends life and yields better sound, as turning gear on and off subjects the tubes to harmful thermal cycles, as well as a voltage rush on power up if the gear uses solid-state rectification, which is most gear. The latter factor is the biggest problem, which is another advantage of tube rectification and why a lot of tube preamps have a "soft-start" feature which applies voltage slowly to the tube filaments on power-up.

And as others have noted, a tube amp with a lot of output tubes will heat up a room (extreme cases, like ARC's 600 series reference amps, basically require a separate room or custom air conditioning unless you are running them in a gigantic room).

I have a solid-state amp (darTZeel) and tube amp (VAC Renaissance 70/70) in my living room, and run the solid-state amp most of the time because, like the poster who spawned your question, I like the convenience of being able to listen whenever I want. The VAC sounds good in 10 minutes, but sounds better after a few hours of operation, and I don't like powering up the amp and exposing it to a thermal cycle when I'm only going to listen for a few minutes. I do run the VAC in the spring and summer when there are frequent electrical storms, as I work far from home and am not able to get home to power down the darTZeel during electrical storms.

Just to be clear, the issue with tube amps and 24/7 operation is that the big output tubes pass a lot of current, even while idling, and this creates undue wear. Small signal-tubes, on the other hand, pass very little current in most circuits, and as I have written ad nauseum in other threads on this forum, when left on 24/7, they tend to either die within 200-250 hours from "infant mortality" (defective manufacture), or they basically last forever.
Maineiac, in my first post on this thread, I answered the Krauti's question. In my subsequent posts, I replied to the responses to my posts. "Revelatory, theraputic (just like a good tube amp).)"? Perhaps stepping way from the tubes for a while might offer you some perspective. It's not as though I am insensitive to many of the charms of tubes. I have yet to hear any speakers that do better with tubes that I care to own.
Good point Raquel. While I sometimes keep my preamp and CD player powered up for days at a time, my hybrid amps get powered down at night or whenever I do not expect to be listening for most of the day. I would expect it to be a good idea to power down fully tubed amps for the reasons you state.
As the original poster of this thread I actually like the fact that this thread has taken on it's own life. Think that's just what happens over time as once the downsides I've asked for have been stated thread drift sets in.

That some folks seem to find it necessary to ask what others may be "on" isn't what I had intended, but then again, I have no power over this thread and shouldn't. But hey, this is where that proverbial grain of salt may be helpful.

Raquel, thanks for a clear answer as to why tube amps shouldn't be run 24/7.

Well, it's a long weekend and as there's more to life than audio gear and so I shall try to catch a fish and check back later on the life this thread has taken on. In a way I agree that it has outlived it's usefullness as my questions have been answered and my decision is still the same. Hiho, hiho, and off to tubes I go, hiho hiho, hiho hiho......

Enjoy the long weekend
As far as how many times the same thing needs to repeated I think once or twice is good enough.