What happened to my room acoustics

I measured the spectrogram for my room at my MLP, and the FFT results are as follows:

- There is a roll-off before 20kHz.

- A dip is present around 12kHz.

- There is a noticeable boost between 50Hz and 1.5kHz.

- The bass rolls off around 33Hz at -3dB, consistent with the factory rating.

Comparing these measurements to the Burchardt measurements, there are some differences:

- It doesn’t exhibit a roll-off before 20kHz.

- The dip is around 15kHz.

- The boost between 50Hz and 1.5kHz is not as pronounced as in my room.

I’m curious about what might be happening with my room acoustics. If a fix is possible, what would it entail?

Spectrogram from my zoom


My room / speakers setup


Measurements from Burchardt


Yeah ive heard of people using the moon blobs...ill trust your not on carpeted floor like i am...were i want stands coupled to floor with spikes.Thanks...glw project.

My stands are on adjustable metal screws, securely anchored without piercing through the carpet.  Moon gels decouple so well that the vibration from the bass is not felt on the stands, and the vibration from the ground is not transmitted onto the speakers.


If you have a good floor the last thing you want to do is decouple the speaker from the floor. Ideally you would bolt it down to the floor. Spikes are the usual option. Why? Newton's 3rd law. You need a very massive, fixed mass (the floor) to control the reactive forces or the speaker shakes. Play a 20 Hz test tone and put your hand on the speaker. What you feel = distortion. Now spike the speaker to the floor and you will feel less shaking. You might also notice more aggressive bass. I'm afraid this whole speaker decoupling gig is an example of lay intuition. If a floor is so bad that it resonates in the audio band then fix the floor. Most floors dampened by carpet might only resonate in the 5 to 10 Hz range, great for causing footfall problems with turntables but not a problem for loudspeakers.

You might want to consider a MiniDSP SHD Studio. This assumes you have your own DACs. It uses Dirac Live which is similar to ARC. This unit is $1,300 and includes streaming. Benchmark Media Systems uses a Studio with their own DACs and is super pleased with the results. It also includes subwoofer crossovers and bass management. 

Ten Misconceptions About Loudspeaker Spikes
Clearing up misunderstandings regarding loudspeaker feet.
Article By Norman Varney see below: