What Power Amplifier Should I Buy?


I am looking to increase my system power. I currently am using a Bryston 2.5B cubed, which is specified at 135 Watts/CH. I am using Revel f208 speakers crossed over at 120 Hz to a 15" HSU sub. The f208 speakers have 88.5 dB sensitivity (Amir measured 88-89dB SPL at 1W into 8 ohms). I sit about 7.5 feet away from the speakers and listen up to 92 dB SPL, but mostly stay between 80-90 dB SPL at my listenin g location.

I have not had power issues. I've never seen a clipping light. I just want more oomph. I've never had a power amp with more power than the 2.5B cubed.

My budget is about $5K. I have been looking at some used 4b cubed amps.

My preamp is a vintage ML No. 38s. Digital from Bryston BDP-3/BDA-3 combo. Analog using Koetsu RS and Shelter 901 cartridges into an SUT (20x) followed by a very vintage Paragon System E used as a phono preamp (I have fully repaired this preamp, particularly the power supply).

I like the sound of the 2.5B cubed. I had a Cary 120 tube amp for some time, but grew tired of the heat and the continuous maintenance, including the insane prices for tubes. I did not experince that great "tube sound" that others rave about. I sold the Cary and went back to the 2.5B cubed.

Will the 4B cubed disappoint?

What other amps should I consifder, new or used?

Thanks for your help!

 

128x128Ag insider logo xs@2xkevemaher

@lynn_olson 

I agree that another sub would help.

I'm confused by your statement about power requirements. Did you mean to say that any amp over 100 W will push the drivers into compression (does this mean non-linear?).  Therefore any amp over 100 W is not recommended for speakers that have the sensitivity that the Revel f208 does.

OP:
 

Measuring your speakers at your listening room could really help understand what oomph you are missing.

Also, of course, having a room that is too reflective acts as a tone control, making the speakers sound brighter and short of enough bass.

In these cases some damping around the room can really help the bass bloom, in addition to improving imaging and clarity.

A good test for this is to get close to your speakers.  Do they suddenly sound much better, with a better bass to mid and treble balance?  Then it's your room.

@erik_squires 

Thanks for the suggestions.

I use REW to characterize and help me improve my sound system. I have extensive traps from a company called "Real Traps". I know where the resonances are. I understand that dips in FR are hard to compensate electronically.

I normally test every component. First, electronic performance and second, in-room performance (listening).

My speakers don't sound any different close up.

What kinds of measurements am I not doing that you think would help me to further understand the performance of my system?

Thanks.

Hey OP,

If your speakers still lack oomph close up it’s not your room for the most part, but it could be your overall levels. Can you post your full range response, including sub and mains?

I should mention, I have a Hsu 15" sub as well and well integrated with the main speaker's it's never lacked for guts.