where to get AudioNote wires

I am looking for AudioNote wire (for arm rewire project) and following another thread

but AudioNote.com doesn't list any distributors in the US. Anybody knows a place where I can get AudioNote wires from
Thank you
Thank you everybody, the list is there, my fault, I just didn't see the 'if' in
'if not mentioned below' on the AN site!
I never did play with silver wiring before sticking to the idea that the copper would give more 'presence', I am going to try silver this time after I looked over what other people saying here (I am gonna do 'copper backup' though :)
Best Regards
Lewm, have you considered running it first through small diameter Teflon tubing, as used to insulate capacitor leads, then through the copper braid? That is what I did with my continuous run tonearm wiring (except for the short section where it needs to be flexible, of course). It works very well that way.
Frogman - what was the teflon tube diameter? I didn't work with teflon much. So I guess the teflon you put just INSIDE the tube, correct? What did you use after that and ouside of the arm base to the pre-amp? Same teflon or something else, would be intersting to know. Thank you
I purchased m Teflon tubing from Michael Percy(.com). He has Teflon tubing as thin as 22 gauge. I think I used 20 gauge. AN wire is very thin so even the 22 gauge will work, the problem is that the thinner the tubing, the more difficult it is to run the wire through it.

I am not sure I understand what you mean by "putting the teflon inside the tube". To be clear: the tube itself is constructed of clear Teflon. The tonearm wires go inside the Teflon tube.
Frogman, Good idea. I have done things like that before, or tried to. In some sense it is trading one problem (threading the fine and fragile wire through a braided shield) for another (threading the fine and fragile wire through teflon tubing). But the latter is probably easier to do.