2. analog
  3. 1329400582

which plinth/tonearm for TD-124 SME or other

hi,
i just scored a Td-124 that i'm looking forward to restoring and i've read a lot of about their potential.

i have two questions.
re: plinth - i have a huge chunk of granite (4" thick) that i rescued from a building demolition in Detroit - and found a granite shop that can cut it and route it for the td-124 table - i'm quite certain it will be heavy - but is there any reason i shouldn't use this as a plinth, vs a good hard wood? i've also read that solid mounting it, or letting it sit flat on the plinth w/o the rubber isolators can produce good results - while i'm not new to the audiophile stuff, i am slowly learning to hear the subtleties that you guys talk about -

2) the tonearm - i was thinking of an SME 3009 - but i'm confused as to which one? the S2, the S3, the S2 improved etc.. I found a decent price on a 3009 S2 Improved, but have heard that it uses a plastic knife-edge bearing -
on ebay, someone sells the cnc bronze replacement for about 30 bucks... is this the big issue with this tonearm? or should i forget about the SME and find something else that will outperform it - or - is a better arm just going to result in diminishing returns for this table??

sorry for the stream of consciousness here - but trying to get a lot answered in one post - thanks
128x128aaronz28
aaronz28's avatar
aaronz28 OP
2 posts
 
well - i have a Grado Master Statement cartridge and the Grado PH-1 -
they are currently mounted in my Td-135 and sound great -but i'm not sure the original thorens arm on that TT is allowing that cart to work its best.

so - lets assume i use the granite plinth, and the grado cart/PH-1

which arm would you suggest? i envision spending somewhere between 500-1000 - any more than that and it would be beyond my budget at this point.

thanks
dklk
38 posts
 

If you are going to use a 9" arm mounted to the std. arm board I would use the rubber gromets. If you are going to use a 12" then I would mount it to a thick solid plinth
jloveys
226 posts
 
I made a 7 cm thick slate plinth for my TD124 and direct coupled the chassis with the original bolts underneath the plinth. Also made a slate tonearmboard. The result is awesome.
http://www.theanalogdept.com/jean_veys.htm
Good luck with your project...
Jean
topoxforddoc's avatar
topoxforddoc
353 posts
 
Here are some ideas
If you want a tonearm that will take standard headshells, then have a look at the Jelco 750.
If you're good at tonearm set-up, then a used Hadcock will get your Grado to sing. Beware if you're a vinyl set up virgin though, as the Hadcock is not the easiest to set up.
If you can go to USD1100-1200, the the Transfi Terminator T3Pro is a fantastic parallel tracking arm and would be great on a solid granite plinth.
More to discover