What is the best type of preamp for a class D amp?


If I were to buy a Spectron Musician III Mk2 which type of preamp would give the best results, within a reasonable budget. Would it be a conventional transistor preamp, or a tube preamp or a class D preamp? If there are any Spectron amp owners who could share their experiences, it would be appreciated.
hifipete
Lots of reviews of the amp see what they liked. What you like may be quite different but I like tube pre amps with all power amps. In this situation it would seem almost a prerequisite.
The reviews that I read suggest using a tube preamp. One suggested an E.A.R. 868. So be sure to try them in your auditioning.
01-30-15: Georgelofi
Many far more technical than me say none yet can be called true hiend, as technology is not yet developed to allow the switching frequency of Class D to be high enough which then has to be filtered out at the end, and that filter not to have an audible/measureable effect on the upper mids/highs of the audio spectrum.
Interesting! I heard some has replaced their BIG BIG $$ amps with Mola Mola Kalugas and the Hypex Ncore NC1200 is a major break through in Class D.

I'm running all tubes and in the market for a SS amp to use in the hot humid summer months and can't believe I'm going to say this, including some Class D amps.
I haven't seem all that many, but it has appeared to me that many seem to have a rather low numerical impedance; which might make a difficult match for many tube pres.
Just like any amp, a pre-amp with low output impedance relative to amp input impedance is best to minimize distortion and for best dynamics. Input impedance of Class D amps run a range similar to others anywhere from 10K ohm to 200Kohm.

For a tube pre-amp 45-60kohm input amp impedance is the minimum. For lower output impedance ss amps, most any amp will likely match well in this regard.

Avoid clipping a all costs and keep noise and distortion to a minimum and audio life in general should be good.