2. amps-preamps
  3. 132511-88961

connecting a sub-woofer to a preamp

I recently purchased an Ayre K-5xe MP preamp and would like to connect a sub woofer to my system to augment the bass response of my ET LFT-8 speakers. Previously with a YBA preamp this was just a matter of utilizing one of the additional output jacks.

However with the Ayre this is not the answer.

Does anyone have any suggestions? The Owner's manual is silent in this regard. I've also e-mailed Ayre twice over the past ten with this question and am still waiting for the courtesy of a reply...

Thanks in advance for any advice that you may care to pass along...

Peter
blues27
yogiboy's avatar
yogiboy
5,622 posts
 
If the sub has a high pass filter you would run a pair of interconnects from the preamp into the subs input then another pair from the subs output to the power amps inputs. Just another option!
donvito101
278 posts
 
I use these!
http://www.audioadvisor.com/prodinfo.asp?number=AQM22FHRD
ghosthouse's avatar
ghosthouse
4,306 posts
 
https://www.audioasylum.com/cgi/vt.mpl?f=general&m=729997
bdp24's avatar
bdp24
9,711 posts
 
Rythmik subs have speaker-level output binding posts.
bennyjammin
9 posts
 
I'm running a sub just fine with my K5xemp. Balanced interconnects to my power amps, and two single endedinterconnects to the inputs of my Fathom F113. 
More to discover