DIY Cat 5 speaker cables....

Natalie, it sounds like you did the "shortcut" approach. It sounds like you basically made a "twisted pair" out of the CAT 5 twisted pairs ??? If so, that is why your amp is not running hot. Whereas your using 16 wires total, Chris' uses 54 wires. It is MUCH more reactive. Using your design, you end up with something that is quite similar to an XLO design and is of appr 15 gauge for each polarity.

We did something similar to your approach on my brothers system, but we took three runs of CAT5 and braided them. This gave us 12 conductors per + & -, leaving us with appr 13 1/2 gauge. Worked okay but always sounded somewhat lean and "splashy". I did not know if this was because we used the "plenum grade" stuff instead of the higher grade teflon jacket or if it was simply the nature of the cable.

I have two pairs of Teflon CAT5's built as Chris designed it. While they have tremendous bottom end, the highs are still somewhat splashy and smeared in my opinion. This cable takes a LONG time to settle in though and i might not have given them enough time. Then again, my brother ran his for well over a year, several hours a day and typically at good volume. They still never "smoothed out" as much as we would have liked. Sean
>

You are right about the bottom end being good its very good.
I do use this cable in my HT set up.I will try it out in my 2 Channel set up sometime.
The plenum grade is teflon.

sean: "splashy"? i like your word a lot but don't really know what it means. is it something like "unfocused" or "close to sibilant" or something else entirely? -kelly

"Splashy" treble to me is a combination of things. Lacking of detail, focus, attack & decay, harmonic overtones, air and the seperation of notes, etc... It can be "close to sibilant" in many cases.

As an example, a cymbal that is cleanly and quickly struck with the tip of a drum stick near the center will produce a very definite rise and fall of sound with natural bell-like overtones. You can pick out the harmonics as the note quickly rises and then slowly shimmers into decay. Think of a good jazz drummer and you'll know the sound that i'm talking about.

On the other hand, a cymbal that is struck with the "meat" or "side" of the stick by a "ham fisted rock drummer" will sound much flatter, lack any specific tonality or overtones and will not have near as pronounced beginning or end. I.E. it is "smeared", "splashy" or "blurred" since it lacks detail, definition, harmonic structure, etc... It is more of a "crash & splash" smearing of notes rather than a "strike & shimmering decay" of notes. Know what i mean ???

As to the bass on Chris' 27 pair CAT 5 design, it has the greatest amount of bottom end and overall "weight" that i have experienced from a cable of that type. If you had speakers that could be biwired and sounded slightly lean and lacked extension, using this cable for the woofers could easily fill things out. If i remember correctly, it is equivalent to about a 10 gauge i.e. Goertz MI-2 or Kimber 8TC but with WAY more "oomph" in the bottom octave. Sean
>

You might want to try this with Cat5E plenum rated cable as it is lower capacitance than Cat5. (Always use plenum rated cable if you are running through walls...it is a safety issue regarding the flammability of the insulation.)