Wilson Alexandria X-2 with ML N33???


Hello,

I waiting my new Alexandria X-2 from Wilson factory, and I'd like to know what is the best way to connect them to my system.
Now I have two pair of MarkLevinson reference amplifiers (N33 and N33H), and two reference preamp (N32).
Is it possible to connect Alexandria X-2 in bi-amp mode? (can I use two of my preamp in this case?)

Thank you for advice.
linn_audio
The factory now ships all X2's with the 28.6 resistor as standard. The 32ohm are only used in special cases such as Spectral or Boulder amps which have very high damping factors.

In my experience the 28.6 significantaly improve the woofer control and perceived bass response they really tighten up the lower octaves. Try them and see which you prefer.

Please let me know me know how you go.
Oh and by the way make sure you change the mid and tweeter resistors at least every quarter. They do decay over time. I change mine every month but then I listen to mine pretty much all the time.

The resistors do get affected by high current heat loads which can change the resistor value under load. Always change them before fine tuning.
Do these resistors also need to be changed in Watt Puppy 7s? I never have seen anything about this but I am putting a lot of power into mine?
No not necessary to change them on the Watt Puppy only the X1, X2 and Maxx are affected by this. I must state that this not a problem simply a way of restoring the sound of the loudspeaker to optimum. If a dangerously high current passes through the resistors they will blow before any damage to the drivers occurs. Sometimes high currents not enough to blow them will damage them and then will cause sonic degradation over time.

I must also state that I am the principal of the Wilson Audio distributor for Australia and New Zealand and a dedicated Audiophile. As such I will try to help anyone on these forums with Wilson Audio products with any questions etc.
Thank you very much for your answer and thank you for offering the advise in the future.

Can the Watt Puppy 7s blow drivers, tweeters etc. or will the resistor blow beforehand? I do crank them. I feel I am only missing the last little bit of bass, but my Watch Dog subwoofer is almost here. I am reluctant to listen to the Maxx 2s or Alexandria for them leaving me wanting too much. This years upgrade path should stop me for a good 2 years. I don't want the extra temptation at this time. Saying that I will listen to them if I am around the corner from them, just no special trips to the dealer (it involves flying & making time which I don't have much these days).

I also might add, hearing the 7s one time started this spending binge. I just wanted that sound in my house.