Can Digital beat our Analog installations?


Having gone a long walk on developing my analog systems I am addicted to phono reproduction. Nevertheless I always kept an eye on CDs and also SACDs. Before I currently updated my digital dCS chain to the complete Scarlatti boxes I experimented on the best wordclocking connections. in the end I decided going for an additional rubidium clock added to my Verona master clock.

I am using also a second system equipped with the Accuphase 800 drive and 801 DAC, an Esoteric XO1 Limited and a Wadia 861 SE for other utilization. Let's concentrate on the dCS stack. These four boxes are sounding such good and analog like that I like to question my friends, Why isn't Digital an alternative to our best analogue chains?

So it's time comparing digital vs. analog systems and maybe some sophisticated digital chains are beating our sophisticated analog systems. Will it be possible?
thuchan
Thanks Lewm. I have submitted the congrats to my purchasement department. btw. they are also contracted on selling some of my units in the next time on Audiogon.
When the last of the four boxes of the Scarlatti system has arrived at me - the Scarlatti Upsampler then exchanges the Purcell - I will answer your question comparing the full system to the R 80.
Hi, I've tried 3 types of clock cables. All were clearly audible. dCS Stock, Cardas Lightning 15 and Purist Proteus Provectus Praesto. I prefer the Purist out of these 3, however the Cardas is a lot better than stock. Seems to bring more focus and lower the noise floor...

Right now still using firewire (I've tried stock and audioquest diamond)....The audioquest again made a improvement...although I though the clock cables was more dramatic and crucial...go figure.

I have not updated to the new firmware yet for AES 2 off the transport to DAC. ( I just have the Scarlatti Trans, Clock and DAC) (have you?) Wonder if AES 2 vs firewire is better for SACD?

What do you notice with with out the rubidium clock as a reference? (and what brand model # pls)

Thanks in advance
Never! The physics of analogue can never be reproduced in the digital mode, no matter what sampling rate is used. Fact, just accept it.
Jfrech,
I am in the process of rebuilding my dCS system to the same configuration you already have. I will also test the AES 2 connection between STT and SDAC and SUP, I may need two more weeks, also with my different cables I am testing. A friend of mine is absolutely excited about running DSD via this connection to the SUP. You should get the dCS update 1.33 for the STT so enabling the Vivaldi mode.

I have tested dCS Firewire, Oyade and Audioquest Diamond (with long endings). The Audioquest is really superior but the Oyade is for the price given not bad too.

Purist Proteus Provectus Praesto bnc to bnc I have not heard. Thanks for the hint.
The SSR Perfection10 Rubidium clock from California is one of possible add ons to your system.
It is an amazing experience in combination with the dCS clock, gives more accuracy on top of the stability you already have with your SCLOCK.

Are you using the SUP (Scarlatti Upsampler)? I was always excited about my upsampling adventures I reached by my Purcell. I would never use a dCS system without upsampler and unpatiently I am awaiting the arrival of the SUP.
09-07-13: Buconero117
Never! The physics of analogue can never be reproduced in the digital mode, no matter what sampling rate is used. Fact, just accept it.
The question raised by the OP was "can Digital beat our Analog installations?"

For that to happen does not require that the physics of analog be precisely reproduced in the digital mode. It just requires that the shortcomings of digital relative to analog, if any, be reduced to the point of inaudibility.

Not sure how that can be declared to be impossible. Not sure how it can even be declared that there are no systems in which it has already been achieved.

Declaring something to be "fact" does not necessarily make it so.

Regards,
-- Al