A Copernican View of the Turntable System

Deat Thuchan - a suggestion while searching for your screws, that you have a glorious opportunity to test out the sp10 on 3 nice footers.

I am sure you must have many lying around ?

Your ET arm :) would require one bolt for it to be mounted for test purposes on a basic arm pod.

Just a thought.

Cheers Chris

Dear Chris,

you are right, many footers are lying around here. Maybe need to clear a bit. Which arm do you mean? EMT 997?

Best & Fun Only - Thuchan

Dear Thuchan

I selfishly meant your Eminent Technology arm.

But any other surface mount tonearm would make this very simple and quick to try out.

Chris

thuchan
the screws can be 140mm long. if you counterbore the 5 holes in the bottom to fit the screw heads to a depth of appx 3/8" that will allow 3/8" penetration into the sp10 thread sockets, which is more than enough. c/b the holes to allow for a washer as well, so 3/8 deep x 3/4 to 1" dia. should work fine.
don

Thuchan, I assume you know this, but in case not, thread size is M5. What material(s) are you using to build your plinth?