A not sarcastic question for the power conditioner/upgraded power cord folks


And I realize that there are those that don’t believe in either

Assuming you use a power conditioner and after market power cords, do you feel that the power cord from the power conditioner to the wall might be a limiting or even a negating factor to the performance of the after market power cords that run from the power conditioner to the gear?

The reason I ask is that I was about to embark upon some more experimentation with different power cords and where I plugged them into when I discovered that the aftermarket cords I had purchased before and some recent arrivals are actually a meter shorter than the ones that came with the gear. This doesn’t matter for the amp due to its location, but when I did my last power cord upgrade I ran my CDP and pre into a conditioner so the length for those didn’t matter either, but as I was doing the musical chairs with power cords thing today, I also was intending to run the CDP and pre straight into the wall on separate dedicated circuits, but I found out that I am a tad short on those two.

Which doesn’t preclude me from moving my dedicated circuit outlets up a couple of feet, and I suppose I probably will, but I was curious as to the opinions about the limitations of a power conditioners power cord.

immatthewj

. . . and speaking of strange, I guess after the thunder we got some freezing rain--I just went to throw a bag of garbage out and stepped onto a skating rink.  We don't really get that all too often here.  

Cool about audience cords. I really like them especially for the amp. Don’t recall if I ever tried XLO…don’t think I did…

If you’re handy you can probably upgrade the captive cord in that power strip but I’m not sure it’s worth the effort. You will need to make a cutout and install IEC connector. Not that big of a deal but still work and money dumped into a 30 year old power strip. Alternative would be this Pangea but I personally never tried it. For $250 or $299 with return policy may be worth a shot. You’ll need a 20A cord or an adapter from Amazon to try with your XLO or Forte. 

Earlier in this thread you mentioned moving the dedicated circuits closer to components. I would say that’s probably your best bet and would allow you to run everything direct. 
 

We got snowed in last night as well around 4” of snow topped off by freezing rain. Very slippery. I skated around a bit while walking my dog. 

I played the best place for the best power cord game for a long time.  Not that long ago I upgraded all my power cords to the same one, a Cardas Clear Beyond.  Up until then I had a combination of Clear M, Clear and Clear Beyond cords.  Immediately everything snapped into place, but best of all my wondering and ongoing experimentation was finally over.

My experience was that the cord from the conditioner to the wall was very important...