As I interpret the information provided at zeroimpedance.com, if the Zero is being used to increase the load impedance seen by the amplifier (as opposed to decreasing it) there is one and only one pair of output wires on the Zero that can be connected to the speaker drivers. The choice of 2x, 3x, or 4x impedance multiplication is made based on which pair of input wires on the Zero is connected to the amplifier. So it appears that you would not be able to connect the 4 ohm driver (plus any resistor you may place in series with it) to the Zero any differently than the 8 ohm drivers.
Regards,
-- Al
Regards,
-- Al