I recently had the cantilever replaced in my Fidelity Research FR1. I chose to go with the original materials, aluminum with line contact diamond. Turnaround was 4 weeks and it sounds excellent. I must say though that the diamond is a lot smaller than the original.
Andy Kim - Needle Clinic
I wanted to put this post out there about Andy Kim of Needle Clinic, located in Bellevue, Washington. As many may know, Andy is a cartridge re-tipper. I tried to find some older posts to add my comments but couldn't find them. So I'll start another OP. I just got my Lyra Kleos back from Andy today. Here's my comments.
My Kleos sounded a little off lately, so I thought it should be checked out. I sent it to Andy Kim. It turns out all that was needed was the stylus required a cleaning and polishing. Andy reported back that the stylus only has about 10 percent wear; IOW plenty of life left.
So I remounted the Kleos today and have been playing all types of music: rock and roll, classical, and so forth. The Kleos sounds wonderful; just great. Kudos to Andy Kim.
Fyi -- some may ask why I didn't send it to Peter Ledermann at Sound-Smith. I seem to recall reading somewhere that he's been unusually busy lately -- and with good reason -- and turn around might be a bit delayed. Also, I'm not sure Peter uses replacement cantilever/stylus assemblies that match (or at least come close to) the original. Andy does.
Anyway, that is a bridge I don't have to cross today.
Bottom line: Andy turned my cartridge within a week of receipt and I am pleased.
My Kleos sounded a little off lately, so I thought it should be checked out. I sent it to Andy Kim. It turns out all that was needed was the stylus required a cleaning and polishing. Andy reported back that the stylus only has about 10 percent wear; IOW plenty of life left.
So I remounted the Kleos today and have been playing all types of music: rock and roll, classical, and so forth. The Kleos sounds wonderful; just great. Kudos to Andy Kim.
Fyi -- some may ask why I didn't send it to Peter Ledermann at Sound-Smith. I seem to recall reading somewhere that he's been unusually busy lately -- and with good reason -- and turn around might be a bit delayed. Also, I'm not sure Peter uses replacement cantilever/stylus assemblies that match (or at least come close to) the original. Andy does.
Anyway, that is a bridge I don't have to cross today.
Bottom line: Andy turned my cartridge within a week of receipt and I am pleased.
- ...
- 117 posts total
@bifwynne not everybody are so happy about Andy's work, read JP Jones comment in this thread https://forum.audiogon.com/discussions/fabulous-technics-epc-100-series-re-tip?highlight=technics%2B... |
- 117 posts total