I just purchased a new VHF marine antenna and VHF marine radio for my boat. My question is, can I use the old VHF antenna by converting the end plug from VHF to AM/FM end plug and simply plug that into my old AM/FM radio? Put another way, is the signal from a vhf antenna usable for AM/FM? I know you can buy a signal splitter and use the output from the splitter for both types of radios. The splitter costs as much as a new antenna. My existing AM/FM antenna consists of a 3' piece of covered wire. Thanks in advance.
Anntenna Question
Hi,
I recently had electricians put a Radio Shack FM antenna on my roof. It's wired with RG-6U cable through a couple of patch panels down to where my receiver is located. Probably about 100' of wire in all.
It doesn't help reception -- in fact, I've gone back to the little wire dipole anenna that comes with the receiver because it sounds better. I put a little Radio Schack antenna amplifier in the mix about 10' from the antenna, and that doesn't help either.
The problem is that I don't know of any way to check whether there's actually a signal on this wire! I have access to bench-quality DVM, but that's about it. Would I require an oscilliscope to check?
I'm also not sure this is the right type of wire, or that I'm hooking it to the receiver correctly.
Any advice appreciated. Thank you!
- Eric
I recently had electricians put a Radio Shack FM antenna on my roof. It's wired with RG-6U cable through a couple of patch panels down to where my receiver is located. Probably about 100' of wire in all.
It doesn't help reception -- in fact, I've gone back to the little wire dipole anenna that comes with the receiver because it sounds better. I put a little Radio Schack antenna amplifier in the mix about 10' from the antenna, and that doesn't help either.
The problem is that I don't know of any way to check whether there's actually a signal on this wire! I have access to bench-quality DVM, but that's about it. Would I require an oscilliscope to check?
I'm also not sure this is the right type of wire, or that I'm hooking it to the receiver correctly.
Any advice appreciated. Thank you!
- Eric
- ...
- 19 posts total
- 19 posts total