Anyone use CD tweaks


I was wondering about the effectiveness of products hyped to improved sound quality - i.e. products like Maple Shade's "Mikro Smooth" for polishing CDs and their "Optrix" surfactant product. You want to believe these claims, but sometimes they sound too good to be true. Anyone with any experience with these or similar CD enhancers??

Thanks in advance...
2chnlben
I use a Hammond bulk tape eraser and demag all my cd, dvds.

I also run my CD player on it's own 20 amp dedicated line,into a Hydra 2 and I use a Shunyata Annaconda Helix power cord.

The sound is much better this way , it rivals my lp set up.

The cd player is an Audio Aero Capitole 24/192.
I enjoyed reading all the comments from all the previous posts and I would like to add the following few remarks. After many long discussions with Ric Schultz (aka Mr. Tweak Audio) I have arrived at a very crazy formula. If your OCD istry the following combo tweaks. First sand the edges of you cd inside and out. Then use Pierre Spreys mikro smooth creme on the cd's surface and then finish the job with Rob Spences Blue MAxx cd cleaner. Then use a cheap permanent marker to blacken both the outside and inside cd edges. Finally take a hair dryer use the cool setting and blast the cd for about 45 seconds (about 12 inches away) you can move it closer and further away while you "blow dry" your cd (actually this technique works better than any the above tweaks) and then place your cd in your transport and be prepared for a wonderful improvement. BTW all of the tweaks I have mentioned DO have some HMMMmmmm pretty "good science" to back up their effects. Keep in mind that all of these twaeks are a pain in the ass. Finally, because of my formal training as a "scientist" I did do a group test on Blue Maxx cd cleaner against optrix and the findings using a six people who had had approximately three glasses of great Zindindel was that the subjects thought that both Optrix and Blue MAxx cleaner were somewhat better than just plain inserting the cd into the palyer drawer. Hey have fun and don't try these tweaks with out professioal supervison.

Best char
Interesting, I also do the sanding, black hole treatment to my cds ,just prior to a demag.

Just run your finger around the edge of a cd and you'll feel a lot of ridges and irregularities.

I was given a demo of the Geman disc cutting machine for cd's and got hooked on trying to do the same at home without the machine.

It works for me.

Those ridges theoretically would influence the spin of the discs in a cd player and perhaps are a source of jitter.

Now all you need to do is try to demag your cd's and lp's.

I should add that I only demag the lps ,cds and dvds.

All other parts of the system are not, but share the benefits.