The solution is to add an autoformer to the Futterman OTL's output. Say, 16 to 32 ohms. This will allow low impedance drive. And a corresponding increase in power/watts from 60 to 120 to 240 from a sextet of 6LF6 output tubes!
Are all amps being built wrong?
The power amplifiers that drive our loudspeakers are mostly built as a low impedance voltage source. They have always been ... but why?
Loudspeakers have a (greatly) varying impedance over the frequency range. A current drive amplifier would eliminate the issues that stem from this varying impedance, and at the same time make discussions about esoteric speaker cables that strive for optimal R, C, L superfluous. Although there still would be these un-measurable ’this (very expensive) cable sounds better’ debates and opinions ... and that’s OK, that’s part of the fun. :)
So ... why are amplifiers not built as a high impedance current source?
This is an interesting read: https://www.current-drive.info/
Loudspeakers have a (greatly) varying impedance over the frequency range. A current drive amplifier would eliminate the issues that stem from this varying impedance, and at the same time make discussions about esoteric speaker cables that strive for optimal R, C, L superfluous. Although there still would be these un-measurable ’this (very expensive) cable sounds better’ debates and opinions ... and that’s OK, that’s part of the fun. :)
So ... why are amplifiers not built as a high impedance current source?
This is an interesting read: https://www.current-drive.info/
- ...
- 81 posts total
- 81 posts total