2. cables
  3. 158956-46

Audio envy - dang!

I usually post on AG when I have an issue or concern, so I’m happy for once it’s to praise a new product, in this case Audio Envy’s IC. 

I use an ARC Classic 60 amp with a Herron 1A preamp. The AE cable went between these two.

I run an ARC Phono pre PH3se from my VPI prime as source.
My speakers are Thiel CS2.4’s

Out of the box a bit bright, But after a few hours that just went to strait up transparent - I mean freaking crystal clear. No tonal aberrations. Smooth, with no etched highs. Voices sound right, Natural. Soundstage opened up, as you might expect when things get clearer.

The best part was how inexpensive they were. They made my Cardas Clear Light interconnects I was using sound clouded by contrast. The Cardas was about x3 the cost of the AE’s.
BTW, this wasn’t “I think I hear differences”, this was “I’ll never use those Cardas in this system again, and where is my IPad, I need to order my next set!”

And that’s just what I did.
last_lemming
maxima95
294 posts
 
jetter

You are likely correct.  Some manufactures hold certain things close to the vest; others not so much.  

There is a picture on the AE site with a good bit of information about the cable, other than gauge, solid or stranded, etc.  He is not using "off the shelf" wires.
  
In my few communications (email) with him, I thought Captain was straightforward and a decent guy. 
jayctoy's avatar
jayctoy
4,066 posts
 
Tellurium q cables I think don’t disclose much of their cables, they are superb too.
turnbowm
353 posts
 

jayctoy2,182 posts10-11-2020 8:35pm"Turnbowm this is not a hype AE pc that I bought are very good, for real."

Which AE power cord did you buy?.
jayctoy's avatar
jayctoy
4,066 posts
 
Turnbowm, I bought the p3 power cord for my Tsakadiris monoblocks tube worth 4K..
jayctoy's avatar
jayctoy
4,066 posts
 
I bought 2.
More to discover