2. analog
  3. 1269027757

Azimuth observations and importance

After adjusting azimuth with a Fozgometer loaned to me, the following is what I observed. Individually, these changes were subtle although noticeable. The combined effect however, was significant to the overall presentation.

Imaging improved.

Vocals became more focused, not as big and wide as before.

Instruments more detailed with greater air. Location is more precise.

Tighter bass versus the slightly lingering bass notes previously.

Better top to bottom detail and clarity.

I never realized how important correct azimuth adjustment is and this exercise was quite a learning experience for me. Thinking I was correctly adjusting azimuth by visually setting the headshell as level as possible was a reasonable but flawed attempt.

I have found at least two stylus issues that if present will affect azimuth and sound.

1) A straight cantilever that is twisted left or right changes the attitude of the diamond and its relationship to the groove. By twisted I mean the cantilever has rotated on its own axis. This one is very difficult to see without appropriate magnification.

2) A cantilever that is canted to the left or right a degree or more but is still straight, not bent. It points left or right probably because it was not centered correctly when the cantilever was installed. It also changes the attitude of the diamond.

What is probably basic and common knowledge to everyone here is something I have just been enlightened about after giving it very little thought. I am now convinced that accurate azimuth is a required step in the turntable set up process and I will be giving full attention to this part of the equation.

No more guesswork and eyeballing which I am embarrassed to say was the norm. Doug
128x128dougolsen
actusreus
733 posts
 
Thank you very much Jtimothya! I actually do have a test record so I'm more or less half way there. Is it me, or is the azimuth one tricky bastard?:)
lewm
12,842 posts
 
I first realized the importance of proper azimuth adjustment when someone demonstrated it to me using his Triplanar tonearm. From that point forward, I lusted for a Triplanar. For a very good treatise on azimuth, how to adjust it, why you are adjusting it, what to expect, etc, I recommend a search of the Vinyl Asylum archives for long posts by B Kearns and by V Khomenko (sp?). Those guys are my bible on this subject.

By the way, I own a now antique Signet Cartridge Analyzer which, if you have the right test LP and a Triplanar, makes setting azimuth a breeze, using the direct output of the cartridge itself, which eliminates the possible effects of downstream amplification. But the Signet does not quite have enough input sensitivity for a modern LOMC cartridge output. It needs an antecedent gain stage.
istanbulu
291 posts
 
I too appreciate the info and perspectives, but I'm left wondering what everyone's thoughts are as to the usefulness of the Fozgometer which at the outset of the thread seemed pretty useful but now I'm not so sure.

Could someone clarify this for me... much appreciated,

:) listening,

Ed
teres
120 posts
 
I am a proponent of using your ears rather than instrumentation for adjusting azimuth. There seems to be a lot of angst about getting this adjustment "right". I assert that "right" is when it sounds best, regardless of what the technical parameters may be. I suspect that in most but not all cases an instrument guided alignment will also deliver the best sound. But since the only thing that matters is the sound, why take the detour into instrumentation.

With good line contact stylus it is very easy to hear when azimuth is properly adjusted. For most people I think it is quite unlikely that using an instrument will result better sound. And there is a distinct possibility that an instrument alignment could produce worse sound.

Some cartridges are considerably less sensitive to exact azimuth and VTA adjustment. Instrumentation does make adjustment easier in this case, but what does it accomplish other than to ease audio neurosis? If you have a cartridge where you can not hear the difference between close and exact then exact adjustment buys you exactly nothing.

Oh, yes and our ears are free.
lewm
12,842 posts
 
Dear Teres, You make a good point, mostly because with most all the cartridges that I have ever bothered to align electrically, there IS no one "correct" setting. Usually I have ended up choosing a setting that gives seemingly the least possible crosstalk in each channel, but as those two values (R into L vs L into R) are virtually never exactly equal, one still needs to use one's judgement. I guess I just don't trust my ears enough to do it all by ear. I generally start with an electrically determined setting and then fiddle with it a little more "by ear".
More to discover