B&W 803D and Parasound


I have recently upgraded to B&W 803D's, driving them with two Parasound 2250 power amps and the 2100 preamp. Anyone have experience with this combination of equipment sounding harsh or too bright?
audiophile21
A tube preamp and a W4S amp would be a better combo. Then too, how the speakers are set up for bass balance and toe in can make a huge difference as well.
They are the prior version,not the latest Diamond series. I am looking at the possibility of power cables as a potential, the only thing I have not looked at.
Done with cheep speakers,etc..I had a pair of Infinity SM150's which were good rock & roll speakers and took a serious pounding from the Parasound equipment over the years. I decided to upgrade being that I listen to jass and auditioned several speakers...The 803's are well worth the money if you have the right equipment driving them. I just have a hard time believing that Parasound is solely the sorce of my problem.
when i first got my 804S they were connected to a pioneer elite receiver and the sound was very harsh... i did a separate amp with the pre outs from my receiver and the harness went away...

i do not know about the parasound first hand, but i do believe there is a point to an amp making the difference..... but not to the extreme of crazy amounts of money for an amp.

Bill
Not sure if your 803s are new or relatively new. I've read a number of comments from those who claimed these speakers sounded harsh/bright when new or relatively new, but once burned in this impression went away, and the sound became very listenable and satisfying. Otherwise, I did have the opportunity to audition several of my classical "test" lps on the current 803 Diamonds in an audio salon and found the entire experience extremely enjoyable. I heard absolutely no stridency or brightness whatsoever. I would be somewhat surprised if the tweeter in your 803 model(preceding the Diamond tweeter) sounded harsh after being broken in. Incidentally, the electronics used in my audition were by Ayre.