Battery powered DAC

For 11 months I've been listening with the Scott Nixon tube dac+ and for about 2 weeks with the Ack dAck! The transport and the amp have been the 47 Labs Shigaraki, though sometimes I stick in my Decware Zen Zen amp or my Consonance 2a3 push push. Speakers have been the single full range Jordan JX92s in a transmission line that goes to a solid 50 Hz. At first, I was taken aback by the more laid back, less round and airy midrange of the dAck! Okay, I told myself, it doesn't have a tube so doesn't sound like a tube machine. With the dAck! the background is so quiet and black it spooked me and I thought, at first, that it did not have subtle detail. Took me a week to convince myself that the dAck! could reveal the hall acoustics, but it can. During the past couple of years I've really pursued a digital front end (within my budget). I've had an Ah!Tjoeb99, Sony SACD-777es, Cary 308, conrad-johnson Premier 9 and DR-1. The Scott Nixon with his better power supply and the nice Shigaraki transport was easily better than the above. Now the dAck! It excells in speed and timing--but perhaps a less responsive amp might not reveal this; the Nixon would sound better with a tube amp--sharing the good qualities of tubes in the midrange. The dAck! can throw hard and deep punches when the music calls for this--bruising my ears with the discovery of new erogenous sensations. The massed violins of an orchestra play melodically to an amazing degree though the dAck! The string basses too. The sweep of strings with the viola and cello slide lush and whole. Percussion: wow, was that snap my solid hardwood speaker cabinets cracking? The waves of the sea of dynamics hypnotize with crests and troughs, then splash one in the face with passionate surprise. Each musician can be heard listening to the other musicians, so precise is the timing (one would swear there exists telepathic communication between masterful musicians). The Ack! dAck! is !!!

Hey all. I know this is an ancient thread but I obtained an original Ack! with no batteries. Just wondering if I can use a single small lead acid 12 volt battery. There are four leads from the connector, 2 reds with caps and the 2 black wires. Looked at the 3PDT, 12 pole switch and it’s a little confusing . One red lead goes to the red wire to the board while the other red goes to what appears to be the ground plane, a green wire. which is jumpered to the associated black wire from the battery harness . The other black wire goes to the black wire to the board jumpered with a cap. I never saw the original batteries so don’t know if they were 6 volts each in series which I would think would only need 2 wires to the switch or 2 12 volt.in parallel. Also thinking of using a larger external battery or a lab grade external power supply. Any knowledge would be appriciated. BTW I didn't want to spring the over $130 Can for the battery pack from Ack .

Not positive but from a more detailed analysis of the wiring it appears the board requires 24 V . In the charge position the 2 reds and the 2 blacks have the 12 v applied to them to the 2 separate batteries which must be 12v each and assume the caps are put across the terminals as some kind of snubbing ?. When in the run position the batteries are put in series to the board with the floating ground to the board connected to the red of one battery and the 'ground' of the other. Maybe someone can confirm this before I proceed. Tnx .