Behringer DEQ2496 - worth using in hi-end system?

Jayboard...You can certainly use multiple EQ curves to suit different recordings. It will be a bit of work to set this up and keep track of which curve goes with which recording. Not worthwhile for me.

You should figure out why the clipping indicator flashed. I have NEVER seen mine flash dispite the fact that I run a relatively high line level feeding out to low gain power amps.

I agree with Eldartford but a remote control to change curves may make it worth while. It's unfortunate that so many recordings were poorly done.

Yes, a little "work" to set up, but not so much trouble to use. I probably will only have a treble boost, a bass boost, and a warmth boost as tone controls. (Those boost modules can function inversely as cuts, since the DEQ allows you to subtract preset eq curves, as well as add them.) I know which recordings are in serious need of general help in those areas; I'm not going to fine tune an eq curve for each one. And I can easily enjoy the variety of tonal approaches that most of my albums present without treatment other than my default room equalization.

A remote control to manage the presets and the Compare and Bypass functions would be outstanding.

The flashing of the clipping indicator is kind of puzzling. I'm using the DEQ only in its digital stages. I should see if different sources change this behavior. Right now I've got an Airport Express feeding a Monarchy DIP that plugs into the DEQ. The DIP boosts the digital signal. Could this be too much of a good thing? I'll experiment tomorrow.

Sounds like you're having fun, Jayboard. The flashing of the indicator when eq is switched in is because the boosted bands go beyond "digital zero." You can adjust gain of the eq module ("gain offset" in the utility menu) to prevent this - I have mine set to -2dB - but I don't hear any problems when the clipping indicator flashes occasionally. Probably there is a safety margin built in, since this is designed for pro use, and many pros use occasional "in the red" as an indicator that they've set the maximum safe level.

I believe the DIP boosts the voltage swing of the digital signal, not the the digitally-encoded level itself, so I don't think that is the issue.

Remote would be great, as would a few other conveniences (e.g., level control on the analog input, coax input, more inputs), but then I suppose the price would go up ..

OK guys...I give. Where does one buy one of these things? I saw the reviewer at enjoy the music.com said he has seen these things at 50% off list price "on the street".

Thanks for the help.

Gregg