Bluesound Node Issues After the Firmware Upgrade


I know a lot of folks own various versions of the Bluesound Node streamers. My Node 2 seems to have survived the 3.10.0 upgrade but my N100 is no longer connecting to the WiFi. The recent maintenance release 3.10.3 did not help.
Anyone else having issues with their Node devices?  
128x128kalali
To add to the frustration, when connection is not possible, you can’t even send a support request because the the blueos app is so truncated in the failure mode.

To effectively use the node streamer, you have to depend on *2* computers to run as expected. The bluesound AND your iPad or phone app etc. I also have constant bluetooth connection problems each day at start up. In retrospect, I would have much preferred a remote to at least decrease these failure rates by 50%.

I am thankful that i still have hard media CD s and an oppo to fall back on.
I have a node 1 that froze up a couple of weeks ago. I just received a new node 2i. I use the node 1 as a paper weight. Nothing worked to revive it. Maybe I’ll try the reset again in a few days.
"I have a node 1 that froze up a couple of weeks ago..."

rocray, if by "freezing up" you mean its stuck in a red LED mode, try reading through the link below, particularly the last few posts and see if that helps. It helped me with my Node N100.
Good luck.
https://support1.bluesound.com/hc/en-us/community/posts/360049475773-Node-N100-stuck-in-red-light-
kalali, thanks for the link. I did try a reset last night,it did start blinking for 20-30 seconds,and then went back to solid red. I will try the reset again ,but this time I’ll connect it via Ethernet cable. The funny thing is my Node froze and I ordered a 2i before this potential fix. Isn’t that the way life goes sometimes? 
I have both a Powernode 2 and the original Powernode N150.  The 2 handles updates just fine, but the N150 will go into a solid red light.  Sometimes connecting by wire will finish the update, but I had to do the last 2 updates via USB stick.  The instructions are on their web page.  Try the USB route before you do a reset.