Cables for Soundlab speakers

What about the sound of your system, do you not like? Is it a lack of bass, high frequencies, imaging or other problems?

Also would help if I knew the source, and preamp. Even a short description of distance from rear and side walls in the listening room would help. This is very critical for all bipolar speakers, and Soundlabs are no different in this requirement.

There is nothing obviously wrong with the system. Imaging could be a bit better as well as bass definition. Source is a SFCD 1 cd player through a SFL 2 pre-amp. Using Bear Labs Silver Lightning XLR interconnects. The speakers are about 3 feet from the back wall, 2 feet from the side walls and about 8-9 feet apart from each other. There is a TV slightly behind the speakers and closer to the left speaker which may be causing some imaging problems? Unfortunately the TV must be there per my girlfriend. I am really wondering if a better speaker cable will help "remove a bit of veil".
Hope this helps, any suggestions will be helpful.

Scon90, based on how you describe your system, I would pull the Soundlab speakers out from the rear wall about another eighteen to twenty four inches, depending on what you can stand visually.

This will open up the imaging, tighten the bass and improve the high frequency resolution without spending a dime. If you don't already have spikes under the Soundlabs, that is a must and a very inexpensive upgrade. If that does not go in the correct direction, post the results and we will have another go at it.