Can a power cord increase the resolution of an Class D (SMPS) amp by more than 5% ?

@atmasphere 

Looking at @dep14 's calculator, it looks like for a typical home-use power cord (16/3 cable at 6' in length) you're only losing .6% of your voltage on a typical 120v 15a home circuit, that seems like it would be well within the margin of error of typical home outlets (which can range from 110v to 130v in actual output).  

Given that amplifiers are typically running at a small fraction of their maximum output (only a few watts except for very short dynamic peaks) how would such a small reduction in voltage actually be audible?  If it were wouldn't you see an even bigger difference between two homes where one's AC voltage averages at 117 volts and another whose voltage averages at 121 volts?

Is there some kind of parameter or specification that indicates power cable bandwidth?

I've never seen one... it would be a good spec to include.

Looking at @dep14 's calculator, it looks like for a typical home-use power cord (16/3 cable at 6' in length) you're only losing .6% of your voltage on a typical 120v 15a home circuit,

In practice you see more- the problem area with many inexpensive cables in the connection at either end. That is where you are most likely to discover that the cable is heating up and this calculator does not take that into account. It also does not calculate the impedance of the cable at higher frequencies, so I can't regard it as 100% accurate, although for general home electrical stuff its fine.

The problem here is that, like it or not, you can hear differences between power cables. My thinking is that if you can hear differences, there should be something measurable as well. I find it easier to measure the effects on the equipment with which the cable is used rather than to measure the cable.

In a class D amp, the idle current is quite low. But to actually make the power to drive real speakers, the amp has to draw power from the wall and at full power can draw quite a lot depending on the amp. If you were to put an ammeter in series with the amp's AC power, you would see the meter dance around as you ran the volume up while playing music. The thing is, switching amps need the power supply to be quiet and the current it needs has to be readily available. Most of the expense of any class D amp is its power supply.

Well, in the case of the new Hurricane power cord from Audioquest you can attribute part of its very high performance to wire directionality, which Audioquest now controls during manufacturing for power cords as well as speaker cables, interconnects and HDMI cables. Hel-loo! Wake up and smell the roses! 🌹🌹🌹

“Well, in the case of the new Hurricane power cord from Audioquest you can attribute part of its very high performance to wire directionality, which Audioquest now controls during manufacturing for power cords as well as speaker cables, interconnects and HDMI cables. Hel-loo! Wake up and smell the roses! 🌹🌹🌹”

What do you mean? Surely it is the bottle of magic pixie dust ($1200 per bottle) that they sprinkle on ordinary wires to make them smell sweet as roses. Hel-loo!

It it will only make it better by 4 3/4 only. Good luck though!!