CD output voltage too high for preamp: what to do?

The endler variable attenuators can be used as a volume control or with an active pre amp. That is what I used them for. Put them at your amp inputs or pre inputs if you only want CD volume reduced.

As I said they work extremely well. They look a little ungainly but are totally transparent.

Downunder

I noticed you have a premier 350, I do as well and since installing it in my system, I too have a gain issue. Do the Endlers have any effect on the sound other than attenuation and I assume by your comment that the Rothwells do effect the quality of sound.

Chuck

Hi Chuck. I use the attenuators plugged into the amp inputs and on about 8db attenuation.That got rid of the gain noise I was experiencig between the pre and power. The Endlers are truely transparent, no real difference between the attenuators attached and not attached, except for the gain.
I was sceptical as well, but decided to try them and I am very pleased., The Rothwell attenuators are quite coloured and change the sound of the amp too much.

BTW, I don't use them anymore as I sold my VTL 7.5 and using a cj pre amp. The cj has the same amount of gain as the VTL, however there is no noise.

Thanks to everyone for their suggestions. I did set the Audible Illusions dip switches to minimum gain without enough of a change in volume. I will look into attenuators both at the pre inputs and inside the AI directly on the CD RCA plugs. Hifi57audio, I'd appreciate it if you'd let me know the formula to calculate the resistor values. I contacted Ayre: they won't adjust the CDP.
Illenema2 thought that the AI pre doesn't do well with attenuators at all. Does anyone have more thoughts on a change in preamp, although that solution is the most expensive!

Just for information, the CD inputs on the AI are not the most transparent. Try the aux. inputs. They're resistors on the inputs of the cd that are not on the other inputs. Art put them there to reduce glare on "Cheaper" CD players. Also, the output #2 has resistors also that, to me, degrade the sound. Always use output #1 for best sound. He did away with these in the L-2. He may have also done that with newer M3a's but I don't know that is the case. It did say in the owners manual.
I would locate the resistors on the main circuit board (I think they are near the dip switch) instead of the input resistors and replace them with the appropriate value. You do not want more in the signal path than absolutely required. Since these resistors are allready there, these would be the ones I personally would adjust.
Call Art Ferris at AI, he's a good guy and would probably help you or at least tell you if it's a bad idea.
The outboard controls would probably be the way to go honestly unless you returned it to him for adjustment.