Channel Balance on Dynavector XV1-S

05-17-14: Moryoga
Since the signal issue changes evenly when I change the tonearm wires on the cart pins from L to R, I think that this rules out the Foz and the test LP as variables.

Moryoga, note in the thread I linked to earlier that the Foz was found to be at fault EVEN THOUGH the imbalance it indicated followed a channel swap at the cartridge pins. I certainly have no idea how that could be, but note also that the OP in that thread reported several others as indicating to him that they had the exact same experience. With one of them indicating that his Foz worked fine with two of his turntables but exhibited the problem with another turntable.

And it appears that in most or all of those cases it was the right channel which measured higher (when the cartridge connections were not being swapped).

This process stated because there was an obvious sound difference between the 2 channels.

That was also the case in the thread I linked to. As you may have already read, it turned out that an unrelated second problem was simultaneously present, which was causing the audible imbalance.

Regards,
-- Al

Almarg, had similar experience with the Foz and an XV-1s. No audible issue though. I could never get the Foz to be similar in both channels as I adjusted azimuth. The difference was constant despite adjustments. Cart checked out fine with voltmeter.

If anyone can point out a gap in my methodology, please point it out.

In somewhat careless fashion, I failed to do a pretty obvious test:

Using the Hi-Fi News test LP track 4 (L Channel, -20db, 25 sec.) Tonearm cables directly into Foz with L to L and R to R, get reading.
Switch L cable to R input Foz R cable to L inout, same reading.

Using Test LP Track 5 (R channel, -20db, 25sec.) Tonearm cables back to R to R, L to L, reading 20% lower than track 4. Same with L to R, R to L.

It seems Track 4 is putting out a 20% stronger signal. So,

Using a db app on a smart phone ( I know it's not the most accurate testing device, but it seems to register in tenths of a db) Play Track 4 L channel, through speakers for 25 seconds, get average reading. Track 5 R channel, which I expected to be 20% less, SAME READING! UGH!

Totally baffled.

Played Cannonball Adderley lp, tried to forget about everything for a little while :)

This is exactly what happened to me. Tonearm directly into Foz. May hit have been 20% difference, but it was different side to side and stayed constant no matter the azimuth adjustments made. Sonically however, was dead equal, both with raw listening and dB measurements just like yours.

I would say don't worry, listen and enjoy the music!