After 7500 series there was Erik Rohmann model, read about it HERE
Classic Ortofon Cartridges: The MC2000 MK II or the MC3000 MK II?
So I have owned quite a few Otofon cartridges over the years, everything from the modest OM cartridges to a couple of Cadenza up to an A90. I typically enjoy Ortofon cartridges.
Now one I have never owned is the MC2000. It seems from a bit of reading I have done that owners of the MC2000 felt it was the most accurate of the Ortofon cartridges, and that releases after it were not its equal.
However, when you look at the MC3000 it has a higher output level that would allow it to work with my Esoteric phono stage. The Esoteric is happy running an MC200 on it which has .09 mV output. but the MC2000 is .05 mV. The MC 3000 MK II is .13 mV from what I find.
Has anyone spent time listening to these classic MC 000 series of Ortofon cartridges? I know there is also a 5000 and 7500, but those seem to be pretty rare.
Regarding the MC2000, I wonder if I use a low mass headshell if I can use it on the Dynavector DV505. I don’t think the mass of the arm in the horizontal plane should affect it, and the vestigial arm can be configured to be an appropriate match for the compliance on this cartridge.
I currently have an MC200u on the arm and its very surprising regarding how good it sounds. Its actually pretty neutral, pretty expressive, but just a bit relaxed in the top end. I certainly enjoy it, but I wonder how these statement cartridges from the classic Ortofon line will sound. These would have been from their long time designer who has now retired, so its a different era of Ortofon versus what their current offerings are. Even though we should acknowledge that the current cartridges use design principals that were developed from this earlier time period and engineering team.
Thoughts?
Now one I have never owned is the MC2000. It seems from a bit of reading I have done that owners of the MC2000 felt it was the most accurate of the Ortofon cartridges, and that releases after it were not its equal.
However, when you look at the MC3000 it has a higher output level that would allow it to work with my Esoteric phono stage. The Esoteric is happy running an MC200 on it which has .09 mV output. but the MC2000 is .05 mV. The MC 3000 MK II is .13 mV from what I find.
Has anyone spent time listening to these classic MC 000 series of Ortofon cartridges? I know there is also a 5000 and 7500, but those seem to be pretty rare.
Regarding the MC2000, I wonder if I use a low mass headshell if I can use it on the Dynavector DV505. I don’t think the mass of the arm in the horizontal plane should affect it, and the vestigial arm can be configured to be an appropriate match for the compliance on this cartridge.
I currently have an MC200u on the arm and its very surprising regarding how good it sounds. Its actually pretty neutral, pretty expressive, but just a bit relaxed in the top end. I certainly enjoy it, but I wonder how these statement cartridges from the classic Ortofon line will sound. These would have been from their long time designer who has now retired, so its a different era of Ortofon versus what their current offerings are. Even though we should acknowledge that the current cartridges use design principals that were developed from this earlier time period and engineering team.
Thoughts?
- ...
- 117 posts total
read about it HERE I own that too. |
edgewear, I never found the MC7500 to sound "edgy" or harsh at all. In fact, I would characterize it as remarkably neutral, almost to a fault, which is to say that if anything it fell a bit short on bringing out the drama and contrasts put into the music by the musicians. But as in most cases where one tries to describe an aural impression, what I just wrote is an exaggeration. It's a very find cartridge, in my opinion. |
- 117 posts total