Connect 3 High Current Amps to a Power Conditioner


I have 2 amplifiers, 1 for my mains and 1 for my center. I also have a powered subwoofer. I am planning to buy a panamax pc with 2 high current outlets + 4 isolated + 5 balanced filtered outputs. Here is verbiage from a review about the high current outlets: "Here the power is only limited by the main 15 amp circuit breaker and other protection circuitry maximizing the instantaneous current needed by the high current amplifiers found in today's home theaters."

I am trying to figure out how I can connect my 3 high current devices to the pc.

main amp: Acurus a250
center amp: Adcom gfa-555ii
Sub: Polk DSW pro 400

Can I connect my main amp and center amp in parallel using a surge strip into one of the high current outlets ? Or is it best to connect sub directly into another outlet in the room and use the 2 high currents for my amps ?

Some addl info:
* I will be using the system mainly for movies.
* I do not have (nor have the expertize/resources to do) any special electrical work done in my media room.

Thx
jengospawn
Post removed 
You say high current drawing. But how high is high?

If you truly have high current or even medium current drawing amps, each amp really should be on its own dedicated circuit/line otherwise the chances are great that each amp (or other components sharing the same circuit) will choke the dynamics right out of the presentation for the other amps. A 26 watt preamplifier is enough to squash the dynamics out of 'high' current drawing amp so I don't know how you can work around that one. Except to acquire dedicated line conditioners and have an electrician install dedicated circuits/lines or get 'low' current drawing amps.

Secondly, and perhaps most important is the quality of the line conditioner. As you probably know many/most line conditioners simply are not worth owning as they do nothing at all, induce their own sonic harm, and/or rob 'high' current drawing amps of the juice they require because the line conditioner is active meaning it's drawing juice to itself and away from the amp that desperately needs it for loud and/or complex passages.

The difference between line conditioning and proper line conditioning is night and day. Regrettably, a good rule of thumb for line conditioning is, if it's a popular name brand, keep searching.

-IMO
From my experiences,no conditioner should be used on an amp.Even my Audience 6 't' version makes the amp. suffer;reducing dynamics.---Even the Ar 12 I own does that. (Even if it is only to a small degree). They all work great on the source but why would one want to lose what has been gained,by doing this?? My best advice is listen carefully,both ways.
The one exception I experienced was when I owned a set of CJ 5 monos. I plugged them both into a Stealth Audio Magic; (early version). "Magic" was the result;--and no sources into this conditioner. Several other conditioners forced me to re bias the amps because the amps sucked up,to much juice.--Proof I could see as the bias lights lit up.
I should add; while I haven't heard every conditioner; I might have owned more conditioners than most. First off, I live in a 95 unit complex (with its very polluted power); and second, I have owned so many conditioners;I can hardly remember all their names; in over 20 years of searching and upgrading. Also, how they respond, using your tv, is a good indicator as to how they do music. "listen and watch"
I agree with Elizabeth that the sub. will be better plugged
direct to the wall.
Sounds like, knowledge is from first hand experience,
like myself.
Concise, practical advice from Elizabeth,I could not have
worded it any better.

I Love My Music!