2. speakers
  3. 1210087993

Dali Helicon 300 with Sansui 9090DB = disaster??

Hi,
I am a total newbie and started buying for the first time in my life (I am 40) decent audio gear (because finally I can, I am a photographer, so it took me a while...), but with very little guidance. All I did was reading tons of threads and bought used from ebay and this site on a whim.
Someone with much more knowledge pointed out to me yesterday that the Dali speakers I just bought are 4 ohm speakers and won't be a good match for my Sansui 9090DB, which I bought to a large extend simply because I loved the retro look of it and people had good things to say about it. I have not even received the speakers yet, but after reading more threads there are conflicting opinions out there, ranging from "everything will be fine" to "I am going to blow my Sansui if listening to music loudly" (which is my full intention!).
Any expert advice? Obviously the speakers were the bigger commitment financially, so I would consider getting a more modern receiver if I needed to.

One more thing to consider is, that if I had to buy another receiver, I would like it to have at least an optical audio input, if not HDMI input, so that I could use it for my projector as well as for stereo listening of music. I am not that interested in surround sound, all I see myself doing is adding a subwoofer, for HT as well as music.

Thanks for any input and helping out a novice!
Nick
sx70nk
dcstep
1,518 posts
 
Hi, welcome to A'gon.

There will not be any problem at all, so far as your amp blowing up, etc. Your Sansui is rated at 110 watts into 8 ohms, which should be plenty. The DALI's 4 ohm nominal impedance will not be too low for the amp. (Solid state amps aren't that sensitive to impedance, at least when it's that high. Getting below 2-ohms starts to become a concern).

I've not tried the Heliccon 300, but I have tried the DALI Helicon 400 which really seemed to like a lot of power to control the bass. If your bass is really bloomy and a little overblown, it's probably the need for a better amp and more power, say 200+ watts into 4 ohms. (It sounded best when we used 1000 watts into 4 ohms monoblocks, really).

Try what you've got, you've got a "cheap" amp mixed with some really nice speakers that'll reveal any weakness in your system. If it turns out that the amp can't do the DALIs justice, then consider a used Bryston and use the receiver's "Pre-Out" to drive the separate amp.

Dave
sx70nk OP
4 posts
 
Thank you Dave,

This is very comforting advice!
dcstep
1,518 posts
 
Glad to help.

Remember, if you're not entirely happy with the Sansui/DALI combination, you can still run with it for a while until you can afford a better amp. Speakers have gotten a lot more demanding of amplifiers since the Sansui's day. I find the DALIs, in particular, to be sensitive to amplification, particularly their bass. Still, your sound might not be optimal, but you will not be harming anything by sticking with that combination.

Dave
More to discover