Fedocable- Your welcome. I suggested the head-amp because in a highly resolving system, I have preferred a high gain active phono stage vs. a xformer. I have very little technical expertise in this area, but I am told that one of the reasons is that xformers can "ring". Also, load matching is critical; I have heard differences in sound between only a couple of ohms in a xformer that has the the ability to swap in different values. I don't think (but really don't know) if that is an issue w the head-amp. Finally, the "step up" effect of the xformer also "steps up" any artifacts from the cable that is upstream of it. The 30 dB gain of the Micro seki is more than adequate and should allow you to run it into the MM side of the project (30 + 40 = 70 dB), which would tend to lower tube noise (if any). It's battery operated so no AC noise issues and has outstanding S/N spec (-120 dB). All that being said, a properly matched xformer can give very good results.
Denon SUT or Micro Seiki head-amp?
Hello there. I recently bought the famous Denon DL-304. I connected it to my Project Tube Box II, and immediately noticed that something was quite lacking. I did some research and only then learned about this cartridge being extremely low-output, and the need to somehow boost up its sound. Right now, the options I have here in Argentina are reduced to:
1) Denon AU-320 step up transformer.
2) Micro Seiki MTA-41 head-amplifier.
The Denon could seem like an obvious option, since it matches the cartridge impedance exactly (40 ohms). But then some say it could veil the extraordinary level of detail of the DL-304, and I wouldn't want that at all. The Micro Seiki, on the other side, is a mystery: there's practically no info about it on the internet. I only got to know that technically it would fit the DL-304: it is good for cartridges between 1 and 50 ohms of impedance and from 0.1mV (DL304's being 0.18). The specs here: http://www.micro-seiki.nl/Accessory.html
Can anyone help me decide here? Thanks for any advice!
1) Denon AU-320 step up transformer.
2) Micro Seiki MTA-41 head-amplifier.
The Denon could seem like an obvious option, since it matches the cartridge impedance exactly (40 ohms). But then some say it could veil the extraordinary level of detail of the DL-304, and I wouldn't want that at all. The Micro Seiki, on the other side, is a mystery: there's practically no info about it on the internet. I only got to know that technically it would fit the DL-304: it is good for cartridges between 1 and 50 ohms of impedance and from 0.1mV (DL304's being 0.18). The specs here: http://www.micro-seiki.nl/Accessory.html
Can anyone help me decide here? Thanks for any advice!
- ...
- 18 posts total
- 18 posts total