Does anyone use wood for vibration control?

I’ve had excellent results with maple and Mpingo discs which are Gabon ebony and African rosewood. But I agree with the previous post that wood can be tricky to work with. The reason you don’t see any cones made of wood with a couple notable exceptions is that wood is relatively soft and will therefore store more energy. Thickness is an issue when using wood for support as thicker boards will resist bending forces better than thinner boards. Note: thank goodness there are no more carbon fiber cones. No offense to anyone. Just commenting on the material, too soft and too funky sounding.

Some DIY sub builders swear by 13-ply Baltic Birch.

Interestingly enough, Ayre supply their latest integrated amp, the EX8 , with 3 Myrtle wood blocks .
And they are quite clear in the manual that the unit WILL benefit from them.
Also of interest about Ayre, I rang them to ask what size fuse rating on my old Ayre ax7e as I wanted to buy a SR Blue fuse for it. They were extremely enthusiastic about aftermarket fuses and acknowledged it would be of benefit.
How about that, an amp manufacturer who is actually on board with tweaks!

Purpleheart and African Padauk are both excellent.  Both about equally hard and dense and heavy which I believe is key.  I have two inch thick bases which also is important.  The thicker the wood the better.  For small components like macmini, modem, power supply, tube traps etc I use even thicker (3 inch thick)  smaller blocks of wood of the needed size that were meant for wood turning or carving from EBay.  

Yeah, right, tried it all. Wood doesn’t control vibration- wood vibrates! Its why musical instruments are built out of it, after all!

The thicker the better works because thicker vibrates less and at a higher frequency. So saying you like thicker better is saying you like the sound of wood- only you would like a little less of it. Which ultimately is why the industry long ago went to MDF- its got all the workability benefits of wood without the characteristic sonic signature of individual wood species.

This is a subject I dove deep into and figured out a very long time ago. Its tough because like I already said there’s a lot of supposedly knowledgeable people recommending pine, birch, coco bolo, whatever. Sounds great until you actually try it. Even worse there’s people spreading outright nonsense, like carbon fiber is soft. Yeah, that’s why they build F1 cars, airplanes and spacecraft out of it, nothing maintains precise geometry like a soft funky frame. Just beyond stupid. No offense to anyone.