No, I haven't done double runs myself gdhal. Paul at Clear Day recommends his Single cable for high impedance/sensitivity speakers, Shotgun for medium, and Double Shotgun for low. I went straight for the Double Shotgun version of the Clear Day speaker cables.
Doubling a Set of Speaker Cables
While reading a "professional "review of the Daedalus Audio Ulysses Floorstanding Speaker, the reviewer is adamant about the improvement TWO sets of speaker cables connected to each speaker - regardless of the brand - makes.
This is something that crossed my mind long ago, prior to reading it now, but I’ve never realistically considered trying it nor have I ever come across this in a review. At face-value it seems to me this technique would do more harm than good. I’m wondering if there are any folks on the forum using this technique of two sets of cables (and as mentioned in the article this is irrespective of bi-amping or merely using a smaller gauge) and if so, can/do you vouch for any "improvement" one should expect.
Thanks.
http://www.dagogo.com/daedalus-audio-ulysses-floorstanding-speaker-and-bass-optimization-woofer-bow-...
This is something that crossed my mind long ago, prior to reading it now, but I’ve never realistically considered trying it nor have I ever come across this in a review. At face-value it seems to me this technique would do more harm than good. I’m wondering if there are any folks on the forum using this technique of two sets of cables (and as mentioned in the article this is irrespective of bi-amping or merely using a smaller gauge) and if so, can/do you vouch for any "improvement" one should expect.
Thanks.
http://www.dagogo.com/daedalus-audio-ulysses-floorstanding-speaker-and-bass-optimization-woofer-bow-...
- ...
- 45 posts total
Vicweast, I have no experience with the Zero autoformers. As you no doubt realize, their main purpose is to increase the load impedance seen by an amp, in situations where the impedance of the speaker itself would be too low to be optimal with the amp that is being used. They are intended to be placed close to the speakers, which will minimize the length and hence the effects of the cables connecting them to the speakers (see the photo of a typical installation on this page). And I would expect the effects of the cables connecting them to the amp to also be reduced, since the resistance and inductive reactance (the inductive form of impedance) of those cables will be a smaller fraction of the load impedance than if connected directly to the speakers. Regards, -- Al |
- 45 posts total