These are probably the guys (ex Dahlquist employees), to which bdp24 referred, that do the Dahlquist repairs/upgrades: http://www.regnar.com/
DQ-LP1 Transformer
Afternoon fellows, Don’t post very often, but get a great deal from your discussions.
I am running 2 McIntosh 2205s to run 2 pairs of DQ-10. 2 MC2100s to power 2 DQ-1W with a c20 preamp. My crossover is a DQ-LP1.
My question has to do with DQ-LP1 upgrade I am trying to do. I’m thinking of changing out the transformer for a higher current in order to accommodate new opamps. Is there a rating that would be ideal? I have just enough knowledge to get into trouble! And also, I am not particularly concerned with being able to put the “lid” back on. Thanks in advance for your input and expertise.
I am running 2 McIntosh 2205s to run 2 pairs of DQ-10. 2 MC2100s to power 2 DQ-1W with a c20 preamp. My crossover is a DQ-LP1.
My question has to do with DQ-LP1 upgrade I am trying to do. I’m thinking of changing out the transformer for a higher current in order to accommodate new opamps. Is there a rating that would be ideal? I have just enough knowledge to get into trouble! And also, I am not particularly concerned with being able to put the “lid” back on. Thanks in advance for your input and expertise.
- ...
- 6 posts total
The
DQ-LP1 use a 35mA transformer, to
accommodate new opamps
with higher current draw, a transformer with 100mA capacity should be adequate. You can find some low profile transformer like this one and not to concerned with being unable to put the “lid” back on. https://www.newark.com/block/fl4-18/isolation-transformer-4-va-2-x/dp/34M6235 |
- 6 posts total