2. speakers
  3. 1440027485

Dynaudio Stand 6 and Contour 1.4' installation

I just got mounting plates for my Contour S1.4's and the Stand 6. The holes don't seem to allow me screwing the Allen bolts into the mounting plates. My dealer says I should be using the provided screws to screw into the base. Should I be drilling into the speaker base? Anyone with experience on this?
benmcosker
jaxwired
232 posts
 
The stand 6 requires an adapter plate to connect to the s1.4. Dynaudio sells the special adapter plate. Contact a dynaudio dealer or contact dynaudio USA directly.
zd542
5,339 posts
 
Jaxwired,

What's so complex about the Dynaudio Stand 6? The instructions are pretty clear and straightforward. That doesn't mean the OP couldn't have made some type of mistake, but I just don't see the complexity.

Benmcosker,

I think I know what the problem is, but I can't say until I you give me an answer to my last post.
benmcosker OP
29 posts
 
The holes on the adapter plate do not match up with the holes in the speaker base.
zd542
5,339 posts
 
You should have 2 sets of spikes that came with the Stand 6. The bigger ones go on the on the bottom of the stand by the floor. The smaller spikes go in the top plate. Thread them into the top plate so that they are pointing up. The speaker sits on the spikes and don't get bolted to the stand.
More to discover