Empire 698 turntable

Are you sure that your 698 isn't just needing a bit of adjustment? The 'table is suspended by the springs which are fixed to the subchassis using wingnuts. The wingnuts are used to level the 'table.

At any rate the springs are attached to their towers from the bottom of the plinth; you will have to remove the subchassis to replace any of them. Its been too many years since I serviced one of these but removing a spring should be fairly straightforward.

I am aware of the adjustment with the wing nuts. However, one of the springs does not seem to be "springing back", as I said previously. I removed the wing nut, and underneath it looks like the spring is held in place by a C-clamp, but I cannot seem able to take it off.

'Circlip' is the expression, and yes they are a bit tricky. IIRC, the mount on the tower is slightly recessed, making it difficult for the circlip to come out on its own. Again IIRC, you should be able to extract it with a medium to small flat bladed screwdriver and a bit of determination. Be careful- those things can go flying!

Yes! You are totally correct! The recessed part is what makes it difficult. But now that I know I am in the right track I will be determined! Thank you for your help.