Look at Dynaudio bookshelf speakers.I own a pair of Dynaudio special forty’s speakers and I own a musical fidelity m6si amplifier.The speakers are a warm sounding speakers that work well with musical fidelity amplifier.
everything sounded great until the upgrade
In short: I loved the sound of my modest system, until I upgraded my amp. Now it sounds pretty horrible. It went from a warm sweet embracing easy-to-listen sound to knives and forks trying to escape from a bathtub.
So...
1. I can just unplug this new amp (used) and sell it
Any other options? I could upgrade my speakers but I have no budget for that.
2. I could sell the speakers and use money to buy used ones that go with the amp.
3. Lastly I could change the source, but was it the culprit - to begin with?
btw - the sound of the "new" amp is decent with my turntable, and terrible with my CD player.
(If I wrote brands and models it would throw the discussion into "A sucks, B is great")
- ...
- 122 posts total
grislybutter, "Seriously. Isn’t it a reasonable goal to make my existing speakers sound good"? You are absolutely correct. Speakers are mega, yet they are still only one ingredient in the stew. My philosophy is different to a lot of philes in two ways. One: - before you spend a penny on gear there are two variables that need your attention. A: The quality of the actual recording that’s being listened to. B: The room you’re playing it in. Two: - The other difference in my equipment philosophy is, it’s my source that I build my system around, not my speakers. Speakers come & go. Without a good source to play a fine recording ya got NADA. "Isn’t it a reasonable goal to make my existing speakers sound good"? Ya think! Optimize your existing set-up. If you’re table (I wish I knew what it was) bests your Cd player, focus on your turntable 1st. Get some isolation pads (IsoAcoustics) under your turntable, amp & speakers. If your table is a cut above consider rewiring your tonearm with a single run interconnect. (this is the only place I’d consider silver over copper). http://www.smetonearms.com/index.php?main_page=page&id=2 Next, get good interconnects. If you’re handy, save some money & make your own http://www.cardas.com/chassis_wire.php, (I like the GRNO 90 RCA connecters), or buy used. Same goes with speaker wire, & I’m glad to say you can do well here without going nuts. Kimber’s Base PR8 will do ya fine. https://www.kimber.com/products/8PR As for bookshelf speaker .... take your time, enjoy what you have. When the time comes ProAc D2. https://www.proac-loudspeakers.com/products/response-d2-r-d/
|
@bigmac1963 current ones are Evoke 20s. I love Dynaudio. I listed to the Special forty’s and I missed the warmth of the Evokes. At the dealer, then and there. So, yes, special forty’s might be the be all end all! |
Very simple, stick to what works. If possible go back to the original amp. The new amp purchase is a mistake. You will be throwing good money after bad replacing everything else including speakers to match the new amp purchase. Why can't you sell the new amp? Do you still have the old amp? If not, this is typically the price paid for "not" leaving well enough alone. We all have been there. |
- 122 posts total