Hello fellow audio enthusiasts. The GOLDMUND Studio and T3b, what do you say about a combo that polarises opinion so much, much the same as did the Linn Sondek in its day. If fitting a pivoted arm to the Goldmund Studio you must ensure you deploy the correct spring combo to balance the suspension, dependant on mass of tonearm; you may need to add some small pieces of lead to the underside of the top plate to facilitate this. My very good friend Nick has recently fitted a Origin Live Conqueror to one Studio( JVCmotor) with truly excellent results. His other Studio( papst motor) has the Excellent Goldmund T3b. The T3b is a difficult arm to set up to be sure and requires great care in set up to elicit maximum performance and to realize its full potential. The Studio plinth must be levelled; then the suspension must be levelled using precision levels( low mass). The crucial part of set up is then to set up the precise horizontality of the rail beds so that all bearing wheels are in contact with the rail tracks over the full length( shining a bright torch from above onto the rails will aid in checking this out) Points to consider:- the belt tension between the pulleys is critical; not to little and not to much; this could trigger premature lifting of the arm; the motor pulley groove needs to be kept clean to ensure stable groove/belt contact to ensure smooth operation of the mechanism and avoid premature lifting. Yes, I own a Goldmund Studio/ GoldmundT3b, since 1986; fitted with a KOETSU Urushi black cartridge, recently rebuilt by Koetsu Japan. I do believe that most enthusiasts are better served with one of the many high quality turntables and tonearms that are available today in abundance. All turntable/arm/cartridge combos need exacting setup; it's just the GOLDMUND COMBO needs a lot more care in set up if you are to truly realise its superb potential.