2. analog
  3. 1110565479

Goldmund Studio/T3 with Helikon cartridge

I recently pur a Helikon on my Goldmund table and have been experiencing some curious issues. The manufacturer specifies a tracking force of 1.75 but in order to get reliable tracking I am forced to use something in the range of 1.9 to 2.0.

Even at that vtf I still occasionally get a record that, although it always played and tracked normally on my previous setup, that the Helikon doesn't like. It skips like crazy in some cases even though the disc isn't warped and/or worn excessively, etc. Very curious.

Anyone care to venture an opinion?
willster
perose
40 posts
 
My experience with the Shure SFG and Helikon is that the reading on the SFG was pretty darned close to what I expected, 1.75gm, when I set up my arm (SME 10) by following the manufacturers directions. The cart tracks wonderfully and sounds great.

The biggest problem that I found was that the SFG didn't have the resolution at 1.75gm that would allow me to draw any meaningful conclusions about the actuat VTF other than it was in the ballpark. The SFG certianly wasn't off by a drastic amount.

Could you have an arm/cart resonance issue?
willster OP
66 posts
 
Here's an update. I purchased a small digital scale recommended by an audiogoner and re-checked VTF. The digital scale reads slighly over 2.1 grams.

This takes us back to the original problem. Why am I having to track the Helikon at higher than recommended force to get proper tracking? My old cartridge had no such problem.
bgpowell
70 posts
 
I am not familar with the turntable/arm so I may be totally off base here. Do you have an antiskate adjustment for the arm? This can cause mistracking often attributed to improper vtf. Just a wild guess on my part.
dougdeacon
3,338 posts
 
Bgpowell,
The T3 is a linear tracker, so no AS adjustment.

Willster,
I've never used a T3 but I just read this in the manual:

IMPORTANT: With some cartridge, the arm may have a tendency to "dive" forward. If so, adjust the back and front rails by tipping the rail slightly forward so that the flap at the end of the tonearm remains in the photo-sensor of the pilot arm when the cartridge is down on the record and rises sufficiently when the arm is lifted up horizontal. The arm should be halfway across the record.

Adjust the 4 screws under the corner of the rail accurately so that it is perfectly horizontal between its front and back supports.

When the above operation is completed, tighten the 4 horizontal screws attaching the rail to the lateral sides.
I'm not sure what that means. Heck, I'm not even sure it's English! But it might help to check that mechanism.

Just a shot in the dark. Good luck!
willster OP
66 posts
 
thank you. Where, may I ask, did you find this manual? I don't have any of this information and thought I had done a fairly thorough search for documentation.

It may not be English to you but, to anyone familiar with the arm, it makes sense.

Will
More to discover