good cable for internal speaker wiring

I used the Cardas Copper Litz wire for wiring my homemade external passive crossover to my Infinity RIIb speakers. I used 11.5 gauge on the woofers, 15.5 gauge on the EMIM mids and 17.5 gauge on the EMIT tweeters.

Litz is not the easiest to work with as every strand must be stripped of insulation, but I found that the resulting sound quality was well worth the work. Lots of details and shimmering highs. I ended up using a Demel tool with a stainless steel wire wheel, and that worked well for the stripping.

By the way, all wires were tinned then directly soldered to the drivers. Pairs of wires (+/- for each driver) were twisted together to reduce RFI pickup - the wires for the three tweeters were then bundled into one Techflex tubing bundle, as were the wires for the three mids, and the woofer wires were put into their own Techflex. Here's a picture of the install:

RSIIb Install

and here's an in-progress picture showing some of the wires bundled in Techflex and some prior to bundling.

Wiring from Crossover

.

Direct is best but as I said not practical for me. The connectors are made by Au-ve-co [Auto-Vehicle Parts Co.] and are marked 8774 [2962447 in parenthesis]. Unplated GM 56 Series Terminals. They are brass and are much better than standard ones. My tech friend told me about them, he has used them for quite a while.

Look to Chris VenHaus of VH Audio. I had Bill Thalmann mod a couple pieces of gear and he used Chris' internal hook-up wire (he has a couple options. Even Bill was impressed.

Thanks, everyone.