Graham Phantom DV XV-1s setup question

Hi Smoffatt,
On the Phantom II with Micro-poise, when you unscrew the knurled chrome cover to access the pivot damping well, the bottom of the 'shank' where it changes from circular profile to square (and then pointed), is coloured blue.
This may not be the case with earlier models?

The Set Up is a bit individual, for example the loading. 100 ohms with Phonostage A is not identical with Phonostage B. It is like a chain, Phonocable, Gain from Preamp, Amp and so on. My choice would be in the 1k area, but it depends on the Phonostage or System.
I would use the range of recommended tracking fore, around 2.0 gr to be on the safe side. Too much is bad for the cantilever and there is also a compression in sound.
Bearing fluid
I use very little of it, it will need some time to settle (room temperature) or you can try a little bit of bearing oil instead.
The break in time is overrated, after a few hours it is the way it is, in general.
Next is that the owner gets used to the Presentation and accept it the way it is (or not). I am skeptical to answers when someone write, the Performance changed dramatically after 100h. I never had this in 15 years with my cartridges.

Hi, anywhere between 1.9 and 2.0 always seems preferred.
Stop overtracking this cartridge! It's insanity at its best. Also, 100 hrs breakin time is the rule. Keep playing, knock off the insane overtracking, and you'll be fine. Sorry, no experience with your arm, why not try your dealer? (just a suggestion)

I have my XV-1s on a JMW 10.5i arm with an VPI Aries 3 table. I actually have my tracking force set at 2.174 g and also have a tad of anti-skate applied. It's still within the recommended range (1.8 - 2.2 g). Not sure if its the arm/table combo compared to the Graham, but 2.174g seems perfect to me.

Thanks for the responses. I moved my VTF up to 2.0 grams for now until there are more hours on the cartridge. I previously had it at 1.87grams which was the weight where the highs and lows seem to balance out, any heavier the highs got dampened any lower the highs were over emphasized. This cross over point might change as it breaks in. Sounds a little dull now. Regarding the damping fluid I am going on the advise of my dealer who said to use none with the XV-1s. He states the damping fluid should only be used with a select few cartridges as it effects how well the pivot works. I tried it both ways with my XX2 MkII and preferred it without fluid. Sounds like most people use the damping fluid, so I will need to try it later once the cartridge breaks in.