Your cartridge is a moving magnet and your turntable should not be ran thru the phono input on your receiver with the phone stage. Assuming you run it thru one of the other line inputs,confirm that you have the correct loading & gain shunts in the correct position in the Sutherland for your cartridge. If all else fails, shoot Ron Sutherland an email. He may be able to advise or help you correct the problem.
Help! Can't Get Rid Of Buzz in system at Higher Volumes
Help! I currently have a VPI Prime Scout TT with a Nagaoka MP-500 Cartridge loaded running through a Sutherland Insight stage/preamp into a Marantz SR7012 AV Receiver. With the turntable input selected on the Marantz, when I turn the volume to around 50 or above without playing a record, I am hearing an annoying buzz that I am unable to get rid of. This is not a 60Hz hum but more like a 120Hz buzz. I've tried using a Furman power conditioner strip, a HumX from EBTech ground isolator, using two different power outlets for different components, different phono cables, a variety of turntable-to-stage ground wires, etc. The noise is not present when using other Marantz inputs. The only thing I haven't tried is installing a coaxial isolating transformer for the coax cable coming from my DirectTV satellite dish (I doubt if this is the problem as I don't notice the noise when the TV Audio Input is selected) and disconnecting a dimmer switch (on the same wall as the A/C outlets that power my audio system) that controls a resessed light over my fireplace mantle. Any suggestions as to what else to try? Thanks much.
- ...
- 16 posts total
@motoraway - he is actually using a Sutherland Insight phono stage which turns the audio signal into a normal level for the Marantz. I don't have direct experience with phono stages and buzz, but if it's a ground loop, this appears to be an alternate solution to cheater plug: http://www.graniteaudio.com/zero/ -a |
- 16 posts total