Home Theater Noob Looking to Upgrade


I have been reading about Home Theater systems, components, upgrading, etc. for days. I had yet to find a good place to really get some good information without it going over my head. I am finally getting pretty well versed in some of the lingo but please bear with me. I want to really up the quality of my home theater, but staying within a reasonable budget.

Background:

As a youngster I wanted a surround sound system so I went out and paid like $300-500 (can't remember) on a all in one 5.1 Panasonic system. Somewhere along the line the electronics of the system failed so I tossed out the subwoofer which powered the system somehow and the receiver where you inserted your dvd's. I kept the center channel, front left and right and rear left and right (all the same speaker).

Recently, back in August or so, I went to my local Best Buy (probably frowned upon but oh well) and picked up a new Samsung LED-LCD-HDTV. I also in the same purchase picked up a new Yamaha RX-V373 and a Polk Audio PSW110 sub-woofer. I am currently using the satellite speakers from the out of the box system. As you can imagine this is less than satisfactory. It has sufficed for the past few months but it is time to upgrade. I have the system set up in a full basement, not sure the square footage or anything, but decent sized.

As I understand it, my current receiver can power 85 watts per channel into 8 ohms (1 kHz) at 0.9% THD (not all that sure what THD is although I have read a little bit about it). I am ready to upgrade the crappy speakers to match up more with my sub's quality. I have a feeling to get some really nice speakers would be a waste with the receiver only pushing 85 watts per channel. I am assuming I am going to need to buy another amp or something to help drive enough power to each speaker, but I am just not figuring out the best and most reasonable way to go about this. I was thinking I should get a new center channel first....Any suggestions?
golfluvr5000
Do you have a budget for your speaker purchase?

More then likely, the 85 watts you have is more then enough (depends a little on what speakers you end up with however)
Well, my overall budget is rather high. I just can't do it all at once. I want very nice speakers is the main thing. I don't care if it takes me a few years to piece it together. I am looking at the Klipsch RC-52 II, RB-51 II, and RS-42 II speakers. I already have a nice-ish sub, as mentioned so I don't want to buy the full RB-51 home theater system, plus I need to resist the urge to just drop $2300 all at once.
Welcome and don't worry, we all have to start somewhere. You are heading in the right direction by pulling away from the HTIB systems like the all in one Panasonic and moving toward a AVR and separate speakers & subwoofer.

From what I gather from all above you basically have a Yamaha AVR, a Polk subwoofer and are looking for 5 speakers to mate with the Yamaha to complete a entry level 5.1 system. First thing you do is discard the Panasonic HTIB speakers as you are right - they are crap!

Second thing to know is that AVR's are rated in a very confusing manner and your receiver is probably putting out only 45-50 watts per channel, all 5 channels driven across the full frequency range of 20hz - 20khz. This is really the only spec that matters - not the hyped up marketing bs of 85 wpc into 1 khz. Despite the actual lower wattage number, this is OK too if you get the right speakers.

So, I would suggest you got back to Best Buy and get some entry level Polk TSI series, to match the Polk sub you aleady have. The TSI speakers are fairly efficient at around 90 db and most important - they are 8 Ohm speakers. 8 ohm speakers are much easier to drive than speakers rated at lower impedences such as 6 or 4 Ohm. Stay away from these! With the small built-in amp in your Yamaha, just stick with 8 Ohm and sensitivity around 90 and you'll be fine. You will be in way to a decent entry level 5.1 system that will be light years ahead of any HTIB.
Thank you, this is some good advice. How about if I am actually interested in a step above "entry level"?
As long as the speakers are 8 Ohm and have a sensitivity of 90 db or higher, your good. The Klipsch Reference your looking at are highly efficient and would work great too. Take at look at the impedence and sensitivity specs of the Klipsch models your looking at and you will see what I mean.